Volvo Penta MD6A MD7A Workshop Manual

69.
Fit the key for the flywheel and push on the fly-
wheel. Fit the thick washer and tighten up the
flywheel with the nut. Tightening torque = 180
Nm (18 kpm = 130 lbftf). Use a counterhold
through the flywheel.
71.  MD6A. Install the stars generator with its
bracket. Screw tight the tensioning bar to the
engine. Earlier engines have a washer placed
between the engine and bracket.
MD7A. Install the alternator with its bracket.
Screw tight the tensioning bar to the engine.
70.
Oil the oil filter rubber gasket. Fit the oil filter and
the oil pressure contact. Screw in the oil filter so
far that the rubber gasket just touches the
engine. Then screw tight a further half turn.
IMPORTANT! Screw by hand.
72.  Install the exhaust manifold. Fit a new gasket.
Check to make sure that the rubber hose for the
cooling water is in good condition. Fit the cooling
water hose from the cooling water pump and
tighten up the hose clamp.
27
Product Specification
CategoriesVolvo Penta Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 44 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(2 votes, average: 3.5 out of 4)
Marine readers have rated Volvo Penta MD6A MD7A Workshop Manual 3.5 out of 4.0 based on 2 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

Volvo Penta MD6A MD7A Workshop Manual SKU UPC Model
seg seg on Jun 30, 2015.

good manual just what I needed


Loo-Dawgie on Mar 20, 2015.

Well i haven't read it yet but it's gonna help me out when I do.


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website