2011 Evinrude 55 hp MFE MRL MJRL Outboard Boat Motor Owners Manual

X INSTALLATION
INSTALLATION
TRANSOM HEIGHT
Make  sure the  transom height  matches the
length of the outboard to be installed.
WARNING
The  outboard  must  not  exceed  the
maximum  horsepower indicated  on     •  A 19  to 21  in.  (48.3 to  53.3  cm) transom
the boat’s capacity plate. Such over-
powering can cause loss of control.
Contact  the  boat’s  manufacturer  if
your boat lacks a capacity plate.
height  uses a  20  in. (50.8  cm)  shaft out-
board.
The shaft  length of  the outboard  being in-
stalled should match  the transom height of
the boat.
Boats  designed  for  remote-steered
outboards might be overpowered by
a tiller-steered outboard of the maxi-
mum rated horsepower. Refer to the
boat manufacturer if you are unsure.
Determine transom height by measuring from
the top edge of the transom, along the center-
line.
Incorrectly  matched  boat  and  out-
board  transom  heights   can  cause
boat instability and loss of control.
Refer to Transom Height.
1
3
Prevent lateral  movement and pos-
sible  outboard   loss  by  using   the
mounting    hardware   supplied    or
size,
strength, and quality. Refer to Install-
ing the Outboard on page 40.
2
hardware
of
sufficient
1.  Centerline
Antiventilation plate
2.
A mounting surface that is damaged
or too thin to support your outboard
while  underway   might   fail  during
operation, causing a loss of control.
3.  Transom Height
Boat   performance   depends   on   outboard
mounting height.
Be   sure   the    boat’s   transom   or      Generally,  the  anti-ventilation  plate   of  the
gearcase should align  with the bottom of the
mounting   bracket    is   structurally
hull.
sound and between 1 5/8 in. (41 mm)
and 2 3/4 in. (70 mm) in thickness.
Test outboard and boat performance at differ-
ent  heights   until  the  best   performance  is
achieved.
IMPORTANT: Use an appropriate hoist to lift
the engine. Refer to Specifications  on page   IMPORTANT:  Be  sure  that outboard  water
pressure  is  not   adversely  affected  by  the
mounting height of the outboard.
38
for engine weight.
39
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude MFE Manual, Evinrude Outboard Manual
Tags, ,
Model Year2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 52 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website