2010 Evinrude 65 hp E-TEC WRL WRY Outboard Boat Motor Owners Manual

STORAGE
LONG-TERM STORAGE
(WINTERIZATION)
WARNING
Outboard must be in NEUTRAL before performing
winterization.  Starting  outboard  in  gear  can  cause
personal injury.
If  winterizing  on  a  trailer,   the  propeller  must  be
removed  before  performing  procedure.  Failure  to
remove   propeller  can   cause   personal  injury   or
death.
3)
4)
After outboard runs for another 15 seconds, advance
throttle grip to HALF THROTTLE position. Outboard will
accelerate to fast idle speed and fog itself.
Allow outboard to run until it shuts itself OFF automati-
cally (less than one minute).
Winterization prepares your outboard for long-term off-sea-
son storage. During winterization, the engine is “fogged”
and extra oil is used to coat internal engine components.
Winterization is complete when outboard shuts itself off.
If the outboard DOES NOT shut itself off,    you may
not have properly advanced throttle grip.
Winterization requires a specific process of steps.
You can confirm your outboard enters winterization mode
when the engine runs at fast idle and:
•  If the engine exceeds 3000 RPM,    the outboard may
have been shifted into gear.
The SystemCheck gauge lights flash (if equipped).
The I-Command gauge displays winterization message
(if equipped).
In either event, immediately press STOP button to turn
outboard OFF and re-start the procedure.
Preparation
Your outboard can be winterized in the water.  If winteriz-
ing in water, make sure the water intake screens are com-
pletely submerged.
1)
2)
3)
Stabilize  the   engine’s   fuel  supply.   Add  2+4   Fuel
Conditioner following instructions on container. Fill fuel
tank.
If winterizing on a trailer, remove the propeller. Attach
a garden hose to flushing port and turn on the water.
Refer to SHORT-TERM STORAGE on page 34.
Outboard must be in NEUTRAL, and shift linkage must
be in NEUTRAL position at all times during winteriza-
tion procedure.
Tiller Control Outboards
1)
Advance  throttle  grip  to  HALF  THROTTLE  position.
Start the outboard. Outboard runs at slow idle speed.
Tiller Control – Typical
2)
After outboard runs for about 15 seconds, move throttle
grip to IDLE position. Outboard continues to run at slow
idle speed.
35
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, ,
Model Year2010
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 64 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website