2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual

X ADJUSTMENTS
ADJUSTMENTS
Trim Tab
Dual standard rotation outboards  —
Move both trim tabs  equally and in the same
direction.
WARNING
Dual outboards (one counter and one
standard rotation)  — Set  both trim  tabs to
the center position.
Improper   trim    tab   adjustment    can
cause difficult steering.
Tilt Limiter Cam
A propeller will generate steering torque when
the propeller  shaft  is not  running parallel  to   If your outboard contacts the boat’s motor well
the water’s surface. The trim tab is adjustable   while tilting, adjust  the tilt limiter  cam to limit
to compensate for this steering torque.
maximum tilt-up.
IMPORTANT:  A single  trim  tab  adjustment
will relieve steering  effort under only one  set
of speed, outboard angle and load conditions.
No single adjustment can relieve  steering ef-
fort under all speed, outboard angle and load
conditions. If the boat pulls  to the left or right
when its load is evenly distributed, adjust the
trim tab as follows:
With the outboard shut OFF, loosen the trim
tab screw. If the boat pulled to the right, move
the rear of  the trim tab slightly  to the right. If
the boat pulled to the left, move the rear of the
trim tab slightly to the left.
Place  the outboard  in  its  normal operating
position. Rotate the tilt  limiter cam — pull its
tab forward and  up to REDUCE the  amount
of tilt UP.
Check  your adjustment  — tilt  the  outboard
fully and adjust  further, if necessary.  Return
the outboard to vertical position for  each ad-
justment, and  repeat your  check after  each
adjustment.
WARNING
Tighten the trim tab screw to a torque of 35 to
Adjusting the  tilt  limiter cam  will NOT
prevent the  outboard  from tilting  fully
and  contacting  the  motor  well  if  the
gearcase hits  an object at  high speed.
Such  contact  could  damage  the  out-
board  and boat  and injure  boat  occu-
pants.
40
ft. lbs. (47 to 54 N·m).
Test the boat and,  if needed, repeat the pro-
cedure until steering effort is as equal as pos-
sible.
High outboard installations  — The
trim
tab might  be above the  water when the  out-
board is trimmed out. Steering effort might in-
crease. Steering effort  will be reduced if  you
trim the  outboard  in and  submerge the  trim
tab.
45
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , , , , , , , ,
Model Year2008
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 62 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(1 votes, average: 3 out of 3)
Marine readers have rated 2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual 3.0 out of 3.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual SKU UPC Model
Rob on Jul 15, 2015.

I have not seen the manual yet. Very difficult to post a review at this point.


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website