2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual

X STORAGE
Remote Control Outboards with Foot
Throttle
After Winterization – All Outboards
1)
After the outboard shuts itself  off, turn key
switch  OFF.   (For  tiller  models,  remove
emergency stop clip  / key switch.)  Do not
start the outboard again after winterization
is completed.
1)
Press foot throttle to HALF THROTTLE po-
sition. Start the outboard. Outboard runs at
slow idle speed.
2)
If winterizing  on a  trailer, turn  off water
and detach garden hose. Grease propeller
shaft splines with recommended lubricant,
and re-install propeller.
IMPORTANT:  When winterizing  is  finished,
leave  the outboard  in  vertical  position  long
enough to completely drain the powerhead. If
equipped, disconnect  the speedometer pick-
up at the upper connection and blow all water
out of the hose using air pressure of 25 psi or
Foot Throttle – Typical
2)
3)
4)
After outboard runs for  about 15 seconds,    less. Reconnect speedometer pickup after all
remove  foot  from foot  throttle  and  allow    the water has been removed.
throttle to return to IDLE position. Outboard
continues to run at slow idle speed.
3)
Top off oil tank.
Extra engine oil is used during the winteriza-
tion procedure. Some excess oil may appear
on the skeg below the gearcase area. This is
normal.
Avoid potential  oil stains  by placing  a shop
towel or suitable container under  the propel-
ler and skeg for the duration of the storage.
After  outboard  runs  for  another 15  sec-
onds, press foot throttle  to HALF THROT-
TLE position.  Outboard  will accelerate  to
fast idle speed and fog itself.
Allow  outboard to  run  until  it shuts  itself
OFF automatically (less than one minute).
Winterization  is   complete  when  outboard
shuts itself off.
If  the outboard  DOES  NOT  shut itself
off, you may not have allowed enough run-
ning time at a throttle position.
If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
In either event,  immediately turn key switch
OFF and re-start the procedure.
37
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , , , , , , , ,
Model Year2008
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 62 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(1 votes, average: 3 out of 3)
Marine readers have rated 2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual 3.0 out of 3.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual SKU UPC Model
Rob on Jul 15, 2015.

I have not seen the manual yet. Very difficult to post a review at this point.


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website