X ENGINE MONITORING
ENGINE OVERHEATING
IMPORTANT: Do not run your outboard— To RESET the system:
even for a brief start-up—without supplying
water to it. Refer to Flushing on page 34.
•
The engine must be shut off and the cooling
temperature restored.
While boating, the outboard’s water intakes IF the S.A.F.E. mode activates and the
must stay completely submerged and unob- stream from the water pump indicator be-
structed. Observe proper transom height and comes intermittent or stops, reduce speed to
trim angle. While the outboard is running, the idle and:
outboard’s water pump indicator must dis-
1)
2)
3)
4)
5)
Shift to NEUTRAL.
SHUT OFF the engine.
Tilt the outboard up.
Clean the intake screens of any blockage.
Clean the water pump indicator of any
blockage.
charge a steady stream of water. Check the
indicator often, especially when operating in
weeds, mud and debris-laden water, and at
extreme trim angles.
6)
7)
Lower the outboard.
Restart the engine and run at idle.
IF cleaning the screens and indicator does
not restore the water pump indicator’s steady
discharge, the engine will operate only in “get
home” mode. Return to harbor immediately.
See your Dealer.
IF cleaning the screens and indicator does
restore the water pump indicator’s steady
discharge, you might have to run for two min-
utes in NEUTRAL to allow the engine to cool
and the light to go off.
1.
2.
Water intake screens
Water pump indicator
IMPORTANT: If cooling is not restored, the
EMM will identify a progressive overheating
condition and shut off the engine. The “WA-
TER TEMP” or “HOT” light will flash. The en-
gine will not restart until the engine is allowed
to cool.
If the engine overheats, the engine monitor
will sound the warning horn and turn on the
“WATER TEMP” or “HOT” light. Also, the
S.A.F.E. (Speed Adjusting Failsafe Electron-
ics) mode will immediately limit the engine’s
speed to 1200 RPM. If the engine was run-
ning faster than 1200 RPM when the S.A.F.E.
mode activated, it will shake noticeably. The
protection system must be RESET before the
engine will operate at speeds over 1200 RPM.
Under certain conditions the EMM will shut off
the engine.
After any overheat causing engine shutdown,
see your Dealer for:
•
Inspection of the water pump for excessive
wear or damage.
•
Inspection of the thermostats.
IMPORTANT: Although the S.A.F.E. mode
can help prevent engine damage, it does not
guarantee you can run your engine indefinite-
ly without engine damage.
19
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 200 hp, Evinrude 225 hp, Evinrude 250 hp, Evinrude CX, Evinrude CZ, Evinrude HL, Evinrude HSL, Evinrude HX, Evinrude PL, Evinrude PX, Evinrude PZ |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Marine readers have rated 2008 Evinrude 200 225 250 hp E-TEC PL PX PZ CX CZ HL HX HSL Outboard Boat Owners Manual 3.0 out of 3.0 based on 1 product reviews. I have not seen the manual yet. Very difficult to post a review at this point.