Connect the clip to the emergency stop/key switch.
Snap the lanyard to a secure place on the opera-
tor’s clothing or life vest — not where it might tear
away instead of activating the stop switch.
Start-up (Cold Engine)
Starting a cold engine normally requires use of the
engine primer. To activate the primer, steadily
PUSH/HOLD the key switch IN while cranking or
running the engine.
With the fast idle lever up, activate the primer while
turning the key switch to the START position. Crank
the engine no longer that 10 seconds. Release the
key upon start-up and quickly adjust the fast idle le-
ver if the engine overspeeds.
2
1
1.
2.
3.
Clip
Emergency stop / key switch
Lanyard
IMPORTANT: The engine will start and run without
the clip connected to the key switch. However, we
strongly recommend that the operator use the clip
and lanyard anytime the engine is running. Refer to
Emergency Stop/Key Switch.
Move the remote control handle to NEUTRAL. Re-
fer to Shifting and Speed Control.
Raise the fast idle lever. The higher you raise the
fast idle lever, the faster the motor will idle in NEU-
TRAL.
1.
2.
PUSH to activate primer
START
IMPORTANT: The starter motor can be damaged if
operated continuously for more than 10 seconds.
Upon start-up, release the key.
If the engine did not start, release the key momen-
tarily, then try again.
Each time the key switch is turned from OFF to ON,
the warning system will self-test. Refer to Engine
Monitoring. If the warning system fails to self-test
during start-up, see your DEALER.
2
If your outboard does not react normally to this
starting procedure or if it fails to start, refer to Trou-
ble Check Chart.
1
1.
2.
Fast idle lever
NEUTRAL
20
- Engine Starting
| Categories | BRP Brand Manuals, Johnson 2-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 25 hp, Johnson 30 hp, Johnson WPL |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)