required by the indications on the dip sticks.
Refer to Table 1: “SAE Viscosity Chart” and your
engine manual included in the owner’s packet.
Follow engine manufacturer’s recommendations.
3. As soon as engine starts, release key to ON
or RUN.
NOTICE
Priming is not necessary for EFI engines. Re-
fer to the engine owner’s manual for additional
information.
DO NOT USE MULTIGRADE OIL. Power steering
and power trim use automatic trans mission fluid.
Check the fluid levels in the vertical drive units or
transmission as often as practical.
C. Shifting and Control Speed
THE FOLLOWING
IFTHELOWEST
SAEVISCOSITY
1. Move shifter control to the neutral detent (idle)
position. This will engage neutral start switch and
allow engine to start. Move the throttle control to
the idle position.
ANTICIPATED
OILSARE
TEMPERATUREIS*
RECOMMENDED
3
2
O
F(0
F(-18 C)to32
Below0 F(-18
o
C)andabove
F(0 C)
C)
SAE30
SAE20W-20
SAE10W
0
O
O
O
O
O
O
*Temperaturerangeyouexpecttooperate.
Note: Useonly singleviscosity oils.
DO NOT shift into FORWARD or REVERSE
unless engine is running. Damage to the shift
system could result from trying to shift without
the engine running. Carefully check function of
all control and engine systems before leaving
the dock.
Table 1: SAE Viscosity Chart
3.
4.
Start and operate the bilge blower system for at
least four (4) minutes before start-up.
Lower the vertical outdrive unit using trim switch
making sure the water intakes are under the wa-
ter.
2.
3.
To go FORWARD - move the shifter control for-
ward.
B. Cold / Warm Engine Start (EFI Engines)
To go in REVERSE - move the shifter control rear-
ward.
1.
Move the control handle to neutral detent (idle)
position. The position of the control handle is typi-
cally in the center or straight up position of the
control. See Figure A1. Notice as you push the
shifter control to the neutral position you will feel
the neutral detent engage thus indicating you are
in neutral. Note: A “start-in-neutral-only” feature
prevents starting the engine while in gear.
NOTICE
DO NOT shift from forward to reverse when
the boat is planing.
NOTICE
DO NOT shift if engine speed is over 800 rpm.
4.
5.
To go from FORWARD to REVERSE, or RE-
VERSE to FORWARD; always pause at NEU-
TRAL and allow engine speed to return to idle.
After shifting is completed, move the shifter control
lever forward or rearward to increase engine
speed.
Figure A1: Throttle Control in Neutral Position
2.
Turn the key switch to start and hold until engine
starts, for no longer than 10 seconds. If engine
does not start, let go momentarily, then try again.
Operation - Section A
Owner’s Manual Page 18
| Categories | Four Winns Manuals, Four Winns SL-Series Manuals |
|---|---|
| Tags | Four Winns SL |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)