NOTICE
NOTICE
DO NOT use a bent or damaged tongue or
coupler. Replacement parts may be ordered
through a Four Winns dealer.
When extending tongue ensure that the brake
line and wire harness are not pinched. Failure
to check could result in damage.
The trailer tongue is hinged or removable on our painted
trailers and galvanized trailers. This allows for easier
storage. The tongue is attached with clevis pin(s) with
locking hair pin(s) or clevis pin keeper(s) to the trailer
frame. Refer to Figure S3.
2. Insert clevis pin. Always be sure to insert clevis
pin from the top and insert the clevis pin keeper.
NOTICE
The tongue will exert some pressure on the
clevis pins. It may be necessary to lift, push or
wiggle the tongue to insert the clevis pins.
Make sure the trailer tongue is secure before
hitching to the towing vehicle.
4.
If towing the trailer, remember to plug the 5-
wire tongue harness to the trunk connector
wire harness of your tow vehicle.
C. Swivel Jack
Thejackisdesignedtolift,lowerandsupportthetongues
of the trailers when not connected to the towing vehicle.
Before unhitching the trailer, use the following guidelines
when setting up the jack.
Figure S3: Trailer Tongue Assembly
To pivot the tongue on trailers models with exposed
hinges:
1.
Pull on the lock pin. See Figure S4.
1.
Make sure the trailer jack is supporting the trailer
load properly. Refer to Section S-2C on Swivel
Jacks for additional information.
2.
3.
Disconnect the trailer from the tow vehicle.
Unplug the trailer’s wire harness from the tow
vehicle’s trunk connector.
Lock Pin
4.
Remove the clevis pin keeper and clevis pin.
NOTICE
The tongue will exert some pressure on the
clevis pins. It may be necessary to lift, push or
wiggle the tongue to remove the clevis pins.
Figure S4: Swivel Jack
5.
Pivot the tongue towards the trailer as far as it will
go.
2.
3.
Swivel jack to the vertical position.
To reinstall, follow this procedure in reverse order.
Release the lock pin and make sure the pin fully
engages the attached tongue bracket.
1.
Pivot the tongue until the clevis pin holes
aligned.
Trailer Information - Section S
Owner’s Manual Page 131
| Categories | Four Winns Manuals, Four Winns SL-Series Manuals |
|---|---|
| Tags | Four Winns SL |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)