2011 Evinrude 75 90 hp E-TEC PL PX SL WEL WEX WDEL WDEX Outboard Boat Motor Owners Manual

   product Information
ADJUSTMENTS
Idle RPM in Gear
High outboard installations  — The
trim
tab might  be above the  water when the  out-
board is trimmed out. Steering effort might in-
crease. Steering effort  will be reduced if  you
trim the  outboard  in and  submerge the  trim
tab.
The idle RPM in gear setting can be adjusted,
if desired, to provide more idle control,  steer-
ing, and quietness in certain applications.
IMPORTANT:  Only your  Dealer  can  adjust
the idle RPM in gear setting.
Dual standard rotation outboards  —
Move both trim tabs  equally and in the same
direction.
Trim Tab
Dual outboards (one counter and one
standard rotation)  — Set  both trim  tabs to
the center position.
WARNING
Improper  trim  tab   adjustment  can
cause difficult steering.
Tilt Limiter Cam
A propeller will generate steering torque when
the propeller  shaft  is not  running parallel  to
the water’s surface. The trim tab is adjustable
to compensate for this steering torque.
If your outboard contacts the boat’s motor well
while tilting, adjust  the tilt limiter  cam to limit
maximum tilt-up.
IMPORTANT:  A single  trim  tab  adjustment
will relieve steering  effort under only one set
of speed, outboard angle and load conditions.
No single adjustment can relieve  steering ef-
fort under all speed, outboard angle and load
conditions. If the boat pulls  to the left or right
when its load is evenly distributed, adjust  the
trim tab as follows:
With the outboard shut OFF, loosen the trim
tab screw. If the boat pulled to the right, move
the rear of  the trim tab slightly  to the right. If
the boat pulled to the left, move the rear of the
trim tab slightly to the left.
Place  the outboard  in  its  normal operating
position.
Rotate the  tilt limiter cam  — pull its  tab for-
ward and  up to  REDUCE the amount  of tilt
UP.
Check  your adjustment  — tilt  the  outboard
fully and adjust  further, if necessary.  Return
the outboard to vertical position  for each ad-
justment, and  repeat your  check after  each
adjustment.
Tighten the trim tab screw to a torque of 35-40
ft. lbs. (47-54 N·m).
Test the boat and,  if needed, repeat the pro-
cedure until steering effort is as equal as pos-
sible.
56
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Document TypeBoat Motor Manual. Marine Operator's Engine Guide.
Tags, , , , , , , ,
Model Year2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 80 pages
Document File TypePDF
Publisherevinrude.com
Wikipedia's PageEvinrude Outboard Motors
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website