X INSTALLATION
Standard vs. Counter Rotation
WARNING
Right-hand propellers are considered stan-
dard rotation propellers. When propelling a
boat forward, the propeller rotates in a right-
hand (clockwise) direction as viewed from the
rear.
Left-hand propellers are considered counter
rotation propellers. When propelling a boat
forward, the propeller rotates in a left-hand
(counterclockwise) direction as viewed from
the rear.
The outboard must be correctly
installed. Failure to correctly install
the outboard could result in serious
injury, death or property damage. We
strongly
recommend
that
your
Dealer install your outboard to
ensure proper installation.
IMPORTANT: Follow all directions carefully.
The outboard’s warranty will not cover prod-
uct damage or failure that results from incor-
rect outboard installation.
Refer to Priming the Oil System on page 16.
Then perform Long-Term Storage (Winter-
ization) on page 46 to prime the oiling sys-
tem.
PROPELLER
Propeller Selection
WARNING
1. Right-Hand (clockwise)
2.
Left-Hand (counterclockwise)
Be alert of people in the water.
Always shift the outboard to NEU-
TRAL and shut off the engine imme-
diately when your boat is in an area
where there might be people in the
water. Serious injury or death can
result from contacting a rotating
propeller or moving boat and out-
board.
WARNING
In dual-outboard installations, check to
make
sure
correct
each
propellers are
before
installed
on
outboard
aggressively operating your boat. Shift
each engine individually into FORWARD
or REVERSE, at idle speed only. If the
boat moves opposite the direction indi-
cated by the remote control handle, the
To select the correct propeller for your boating wrong propeller has been installed on
application, your boat and outboard MUST be
water tested. See your Dealer for assistance.
the outboard being checked.
IMPORTANT: The correct propeller for your Propeller Installation
boat, under normal load conditions, will allow
the engine to run near the midpoint of the
NOTICE
RPM operating range at full throttle. Refer to
Apply Triple-Guard grease to
Specifications on page 58.
the entire propeller shaft before installing
the propeller. At least annually, remove
the propeller and check for debris. Clean
the shaft and regrease it before reinstall-
WARNING
When servicing the propeller, ing a propeller.
always shift the outboard to NEU-
TRAL position, turn the key switch
OFF, and twist and remove all spark
plug wires so the outboard cannot
be started accidentally.
Slide thrust washer onto shaft with shoulder
facing aft.
Slide propeller onto shaft, engaging the
splines and seating it on the thrust bushing.
53
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 75 hp, Evinrude 90 hp, Evinrude PL, Evinrude PX, Evinrude SL, Evinrude WDEL, Evinrude WDEX, Evinrude WEL, Evinrude WEX |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)