PRODUCT INFORMATION
Remove the cotter pin and loosen the impeller nut. Re-
move the nut, spacer, impeller, and thrust bushing.
TILLER HANDLE ATTACHMENT
The tiller handle can be removed without tools to minimize
required storage space.
5
4
To attach tiller handle to the outboard:
•
•
•
Place shift rod through shift lever.
3
1
2
1
1.
2.
3.
4.
5.
Cotter pin
Impeller nut
Spacer
2
Impeller
Thrust bushing
Installation
1.
Shift rod
2.
Steering arm studs
Place tiller handle bracket on steering arm studs and se-
cure with hand nut.
Apply a small amount of Triple-Guard grease to the impel-
ler shaft splines. Place the thrust bushing in the impeller
and then slide the assembly onto the impeller shaft.
Install the spacer on splines of the impeller shaft.
Install and torque the impeller nut 14 to 16 N·m (120 to
140
in. lbs.).
If cotter pin holes in the impeller nut and impeller shaft are
not aligned, continue to tighten the nut until they are in line.
Do not loosen.
Insert a new cotter pin through the impeller nut and shaft.
Bend its ends over the nut to secure the assembly.
1
Install the impeller housing, and following sequence
shown, tighten screws in stages to a torque of 8 to 12 N·m
(70 to 100 in. lbs.).
1.
Hand nut
Install washer and retaining clip on shift rod.
1
1.
Retaining clip
42
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude MFE Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 55 hp, Evinrude MJRL, Evinrude MRL |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)