FUEL AND OIL
OIL REQUIREMENTS
Small bubbles are acceptable. Large bubbles must be
eliminated through continued priming.
Evinrude/Johnson XD100 is the ONLY outboard oil rec-
ommended for use with Evinrude MFE
outboards.
Evinrude/Johnson XD100 outboard oil MUST be used
when outboard is run on heavy fuels. Evinrude/Johnson
XD100 oil MUST be used when operating in temperatures
under 0°C (32°F).
1
2
In combat emergency if Evinrude/Johnson XD100 oil is
not available, you must use an oil that meets NMMA TC-
W3 certification standards. Operating time should be limit-
ed to the duration of the combat emergency and the oper-
ator should return to operating on Evinrude/Johnson
XD100 as soon as possible.
1.
2.
Large bubble
Small bubbles
OILING SYSTEM OPERATION
IMPORTANT: Failure to follow oil specifications could void
the engine warranty if a lubrication-related failure occurs.
Break-In
New outboards are programmed to use additional oil dur-
ing the first two hours of operation above 2000 RPM. No
other action is required by the operator.
FILLING THE OIL TANK
Remove the engine cover to access the oil tank. Remove
the filler cap and fill the tank with the recommended out-
board lubricant. The oil tank capacity is 1.9 liters (2.0
quarts).
IMPORTANT: DO NOT add oil in the fuel tank.
NO OIL Warning System
When the level in the oil tank falls below one-quarter:
•
The EMM interrupts the ignition once per 50 engine rev-
olutions to signal the operator.
The EMM then calculates remaining oil level based on oil
pump pulse cycles. When it determines the oil has been
used, the EMM:
•
Limits engine speed to 2500 RPM.
To recover from NO OIL mode, stop the outboard and add
oil to tank. The warning resets after the pump cycles for a
minimum of three pulses with the oil level above one-quar-
ter.
Replace the filler cap and tighten securely. Reinstall the
engine cover.
PRIMING THE OIL SYSTEM
The oiling system must be primed before using the out-
board if:
•
•
•
The outboard is new;
You run completely out of oil; or
The outboard is laid down for transportation or storage.
If available, use the Evinrude Diagnostics Software pro-
gram oil priming function for a minimum of 90 seconds.
If the diagnostics program is not available, prime the oiling
system by using the winterization procedure. Refer to
LONG-TERM STORAGE (WINTERIZATION) on page 33.
Observe oil flow through the oil distribution hoses.
15
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude MFE Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 55 hp, Evinrude MJRL, Evinrude MRL |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)