PROPELLER
WARNING
When servicing the propeller, always shift
the outboard to NEUTRAL position, turn the
key switch OFF and disconnect battery pos-
itive (+) cable so the engine cannot be
started accidentally.
IMPORTANT: Apply Triple-Guard grease to the en-
tire propeller shaft before installing the propeller. At
least annually, remove the propeller and check for
debris. Clean the shaft and regrease it before rein-
stalling a propeller.
100 FPL, FSL, and 115 FPL, FSL models
1.
2.
3.
4.
Thrust washer
Spacer
Propeller nut
Cotter pin
Installation
Slide thrust washer onto shaft with shoulder facing
aft.
Slide propeller onto shaft, engaging the splines and
seating it on the thrust bushing.
Slide spacer onto the shaft and engage the propel-
ler shaft splines.
Wedge a block of wood between the propeller
blade and the anti-ventilation plate.
All other models
Install propeller nut and tighten to a torque of 70-80
ft. lbs. (95-108 N·m).
Install keeper on propeller nut, align keeper slots
and cotter pin hole.
Install new cotter pin and bend ends to secure.
All other models
100 FPL, FSL, and 115 FPL, FSL models
1.
2.
3.
4.
5.
Thrust Washer
Spacer
Propeller nut
Cotter pin
Keeper
Install Propeller nut and tighten to a torque of 120
in. lbs. (14 N·m).
Continue to tighten propeller nut until nut slots and
cotter pin hole are aligned. Install new cotter pin
and bend ends to secure.
Remove block of wood. Make sure engine is in
NEUTRAL; give propeller a spin. It must turn freely.
48
- Maintenance
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 100 hp, Evinrude 115 hp, Evinrude 135 hp, Evinrude 150 hp, Evinrude 175 hp, Evinrude 200 hp, Evinrude 225 hp, Evinrude 250 hp, Evinrude FPL, Evinrude FPX, Evinrude FSL |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)