2010 Evinrude 100 115 135 150 175 200 225 250 hp E-TEC FPL FSL FPX Outboard Boat Owners Manual

IMPORTANT: The engine will start and run without    IMPORTANT: The starter motor can be damaged if
the clip connected to the key switch. However, we
strongly recommend that the operator use the clip
and lanyard anytime the engine is running. Refer to
Emergency Stop/Key Switch.
operated continuously for more than 10 seconds.
Upon start-up, release the key.
If the engine did not start, release the key momen-
tarily, then try again.
Each time the key switch is turned from OFF to ON,
the warning system will self-test.   Refer to Engine
Monitoring. If the warning system fails to self-test
during start-up, see your DEALER.
Move the remote control handle to NEUTRAL.
If your outboard doesn’t react normally to this start-
ing procedure or if it fails to start, refer to   Trouble
Check Chart.
After Engine Starts
IMPORTANT: DO NOT advance the throttle when
operating the engine in NEUTRAL. Advancing the
throttle can cause the engine to over-rev, which can
result in severe engine damage.
1
6
2
Check the water pump indicator. A steady stream of
water  indicates  the  water  pump  is  working.  If  a
steady stream of water from the water pump indica-
tor is not visible, stop the engine. Refer to  Engine
Overheating.
1.
2.
Concealed side mount control
Binnacle mount control
DO NOT advance the throttle before start-up. Ad-
vancing  the  throttle  overrides  the  electronic  idle
control system. After the engine starts, the engine
management module (EMM) automatically increas-
es idle speed. Idle speed will decrease as the en-
gine  warms  up.  Wait  until  idle  speed  decreases
before you shift into gear.
WARNING
DO  NOT  attempt  to  shift   the  engine  into
FORWARD or REVERSE while it is running
at fast idle. Shifting under this condition can
result in sudden boat movement, resulting
in injury.
Engine temperature will determine the length of the
period of fast idle after start-up — the warmer the
engine, the shorter the period of fast idle.
Turn the key switch fully clockwise to the START
position. Crank the engine no longer than 10 sec-
onds.
Engine Starting -  27
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , , , , , , , ,
Model Year2010
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 60 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website