BATTERY
WARNING
Each outboard needs one battery that is:
Do not use a booster battery and jumper
cables to start the engine. Fumes vented
can cause explosion and fire, resulting in
property damage, serious injury or death.
•
•
Rated according to the minimum requirements in
Engine Specifications.
12-volt, heavy-duty, designated "marine"
Vented/refillable or maintenance-free
Deep-cycle batteries are suitable IF they meet or
exceed the minimum CCA requirements.
Refer to Engine Monitoring and review your en-
gine’s warning system self-test routine. During your
preseason start-up, make sure the warning system
self-tests properly. If it doesn’t, see your DEALER.
Ask your DEALER about your outboard’s require-
ments before installing longer battery cables or a
battery switch.
Follow Engine Starting in the Engine Starting
Never install an after-market battery isolator. Your
outboard has a built-in accessory battery charging
feature. Refer to Accessory Battery Connection.
Section and start the engine. Let it idle while you:
Observe running quality - if poor, refer to Trouble
Check Chart or see your DEALER.
Observe water pump operation. Water must flow
from the water pump indicator in a steady stream. If
it doesn’t, shut off the engine and investigate. Refer
to Engine Overheating.
Installation
Read and understand the safety information sup-
plied with your battery BEFORE you begin installa-
tion.
Stop the engine and check the fuel system for
leaks.
IMPORTANT: You must use the adapter clamps
and starwashers supplied with this outboard when
installing the main battery cables to the cranking
battery. Any other type of installation can damage
the electrical system or EMM.
WARNING
Make sure all components are clean and free of
corrosion.
Connect the RED (+) main cable to the positive (+)
battery post. Connect the BLACK (-) main cable to
the negative (-) battery post.
Failure to check for fuel leakage could allow
a leak to go undetected, resulting in fire or
explosion.
If you have marine battery posts, install each main
cable on the clamp adapter with a starwasher be-
low it. Install all wires from accessories on the
threaded portion of the post.
1.
2.
3.
Main Cable
Starwasher
Accessory wires
Maintenance - 41
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 100 hp, Evinrude 115 hp, Evinrude 135 hp, Evinrude 150 hp, Evinrude 175 hp, Evinrude 200 hp, Evinrude 225 hp, Evinrude 250 hp, Evinrude FPL, Evinrude FPX, Evinrude FSL |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)