Chapter 11: Electrical System
Battery Switch Positions
NOTICE
Since your boat’s batteries were installed by your dealer, the battery switch positions listed
below may vary. Make sure your selling dealer fully explains how to use the battery switches.
BATTERY SWITCH
POSITIONS
ENGINE
STARTING
ENGINE
ALTERNATOR
BATTERY
CHARGER
ACCESSORIES & LIGHTS
Battery 1
Provides Start-
ing Power
Battery 1
Provides Power for
Accessories and Lights
POSITION
"1"
Charges
Battery 1
Charges BOTH
Batteries
Battery 2
Provides Start-
ing Power
Battery 2
Provides Power for
Accessories and Lights
POSITION
"2"
Charges
Battery 2
Charges BOTH
Batteries
BOTH Batteries Provide
BOTH Batteries
Provide Start-
ing Power
"BOTH" or "1 & 2"
POSITION
Power for Accessories and Charges BOTH
Charges BOTH
Batteries
Lights (not advised unless
engine is running)
Batteries
Fuses & Circuit Breakers
•
Circuit breakers for engines and main accessory power are on the 12-volt DC push-to-reset circuit breaker panel
and on the battery switch panel.
•
For the locations of the battery switch panel and the 12-volt DC push-to-reset circuit breakers, see the Component
Locations section in Chapter 2 of this supplement.
NOTE: Some equipment may have secondary fuse protection at the unit, behind the battery switch panel, or at
the batteries.
12-Volt DC Accessory Outlets
!
CAUTION
Do NOT use the 12-volt DC accessory outlet with a cigarette or cigar lighter. High tempera-
tures may melt the outlet.
•
•
The outlets can be used with any 12-volt device which draws 10-amps or less.
The 12-volt DC accessory outlet is protected by a 10-amp breaker on the 12-volt DC push-to-reset circuit breaker
panel.
•
For the locations of the 12-volt DC accessory outlets, see the Component Locations section of Chapter 2 in
this supplement.
82
| Categories | Maxum Manuals |
|---|---|
| Tags | Maxum 2700SE |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)