Chapter 6: Plumbing
Water Heater
!
WARNING!
SCALDING HAZARD!
Water heated by the water heater can be hot enough to scald the skin.
!
CAUTION
WATER HEATER DAMAGE HAZARD!
•
Do NOT turn On the water heater circuit breaker on the 110-volt AC master panel until the
water heater tank is COMPLETELY filled with water.
•
•
•
•
The tank is full if water flows from the tap when the hot water is turned On in the galley.
Even brief water heater operation with a dry tank WILL damage the heating elements.
Warranty replacements will NOT be made on elements damaged in this manner.
Drain the water heater and turn the power Off when the chance of freezing exists (see the
winterizing instructions below).
NOTICE
If 110-volt AC power is being provided by shore power, but the water heater is not working:
•
•
Make sure the water heater circuit breaker on the 110-volt AC master panel is switched On.
If the circuit breaker is On, but the water heater is still not working, ask your dealer how
to check the push-to-reset circuit breaker located on the water heater.
•
•
•
Read the water heater instruction manual and heed the warnings above.
The water heater is connected to the 110-volt AC power system.
To heat the water, turn On the water heater circuit breaker on the 110-volt AC master panel.
Winterizing the Water Heater
NOTICE
The freshwater system MUST be drained BEFORE winterizing the water heater (see the
Freshwater System Winterization Instructions on the previous page).
1.
2.
Turn Off the water heater breaker.
Disconnect the hose (A) attached to the pressure
relief valve (B).
3.
If there is any water in this hose, drain it into the
bilge or into a bucket.
Open the pressure relief valve (B).
Open the drain valve (C).
Leave the pressure relief and drain valves Open until
you fit out your boat after storage.
B
A
4.
5.
•
C
51
| Categories | Maxum Manuals |
|---|---|
| Tags | Maxum 2700SE |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)