ADDITIVES
Prime the fuel system by holding the fuel primer
bulb with its outlet end up and squeezing it until
firm.
IMPORTANT: The only fuel additives approved by
BRP for use in your Evinrude outboard are 2+4®
fuel conditioner and Evinrude Fuel System Cleaner.
Use of other fuel additives can result in poor perfor-
mance or engine damage.
Evinrude 2+4 fuel conditioner will help prevent
gum and varnish deposits from forming in fuel sys-
tem components and will remove moisture from the
fuel system. It can be used continuously and should
be used during any period when your engine isn’t
being operated on a regular basis. Its use will re-
duce spark plug fouling, fuel system icing and fuel
system component deterioration.
Evinrude Fuel System Cleaner will help keep fuel
injectors in optimal operating condition.
FUEL SYSTEM
IMPORTANT: Fuel distribution hoses in the boat
must deliver fuel at the rate of flow needed by the
engine. Minimum inside diameter of fuel hoses
must be 3/8 in. (9 mm).
Connecting the Fuel Hose
Fuel systems with built-in tanks, particularly those
that include antisiphon valves and filter/primer
units, may have restrictions that will not allow the
engine fuel pump to deliver sufficient fuel under all
conditions. This can result in a loss of performance
and possible engine damage. If a performance
problem exists, see your Dealer.
To avoid difficulty when restarting, never run the
engine with the fuel hose disconnected or run the
engine out of fuel.
WARNING
The outboard must be correctly installed.
Failure to correctly install the outboard
could result in property damage, serious
injury or death. We strongly recommend
your Dealer install your outboard to ensure
proper installation.
If the fuel hose is disconnected for any reason, seal
it to prevent spillage. Cap the fuel fitting to prevent
contamination.
Connect the fuel hose to the 3/8 in. (9 mm) fuel fit-
ting. Fasten hose securely with clamp (18,5 mm)
from owner’s kit.
1.
2.
3.
Fuel hose and fuel fitting - 3/8 in. (9 mm)
Oil supply fitting - 1/4 in. (6 mm) - Yellow stripe
Oil return fitting - 5/16 in. (8 mm) - Blue stripe
Fuel and Oil - 21
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 115 hp, Evinrude 135 hp, Evinrude 150 hp, Evinrude 175 hp, Evinrude Direct Injection, Evinrude FCX, Evinrude FHL, Evinrude FPL, Evinrude FPX, Evinrude FSL |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
necesitaria el manual del motor etc evinrude 115 hp año 2012 en castellano