1..
2..
.Avoid.working.in.direct.sunlight..This.dries.out.the.
wax.or.compound,.and.can.stain.the.surface.
use.either.denatured.or.rubbing.alcohol..If.this.does.
not.work,.consult.your.Four.Winns.dealer.for.profes-
sional.assistance.
.Use.clean.pads.or.cloths.to.apply.a.thin.coating..
of.wax.or.rubbing.compound.to.a.small.area.such.
as.three.feet.by.three.feet..Remove.any.excess,..
and then rub the area with a buffing pad, or .
power.buffer..Apply.pressure.only.as.necessary..
to restore the surface finish. Applying too much .
pressure or buffing in one place too long can .
permanently.damage.the.surface.
NOTICE
DO NOT use acetone, ketone, or other
solvents to remove stains. These chemicals
are flammable and may damage the gel coat.
P - 5 FIBERGLASS REPAIRS
3..
.
.After.applying.compound,.always.follow.with.
waxing..
Fiberglass.is.one.of.the.most.durable,.strong,.and.
forgiving construction materials afloat. It is resilient
and.normal.repairs.can.be.made.without.affecting.the.
strength.or.structural.integrity.of.the.boat.
NOTICE
If using a power buffer, use a low RPM buffer
with light pressure. Keep the pad wet and
the buffer moving at all times to prevent heat
build up.
Striking docks, other boats, or submerged
objects could create a very hazardous situ-
ation or severely damage the fiberglass. In the
event an object is struck below or near the
waterline, proceed directly and cautiously to
the nearest service facility and remove the
boat from the water. Closely inspect the hull
for damage. If the outer fiberglass laminate
was penetrated, repairs must be made prior
to relaunch.
NOTICE
When sanding, DO NOT use a power or belt
sander to prevent gouges, uneven areas, or
other damage. For best results, block sand the
gel coat.
C. Stains
Stains.can.appear.anywhere.on.the.exterior.of.the..
boat.and.may.be.a.result.of.contact.with.tar,.plant.sap,.
leaves, rust from metal fittings, and other materials.
Surface.stains.may.be.removed.with.hand.dishwash-
ing.soap,.mild.cleansers,.or.some.household.deter-
gents..DO.NOT.use.chlorine.or.ammonia.products..
These.products.can.affect.the.color.of.gel.coat..
Commercial.car.washes.use.strong.cleaners.and.
should.be.avoided.
Occasionally,.blisters,.crazing,.scratches,.or.damage.
to the fiberglass can occur. Repairs may be necessary
to.correct.the.problem..
A. Scratches
Scratches.occur.during.normal.use..Below.is.a.step.by.
step.procedure.to.repair.scratches.
1..
2.
3..
Clean.area.with.soap.and.water.
To.remove.stains,.refer.to.the.procedures.below.
Apply a fine rubbing compound and buff.
1..
2..
Wash.area.with.hand.dishwashing.soap.
Wax..If.this.does.not.work,.clean.the.area.and..
sand.lightly.with.400.to.600.wet.or.dry.sandpaper.
and.follow.with.rubbing.compound.and.wax.
.Begin.with.a.small.area.such.as.three.feet.by.three.
feet.and.apply.a.mild.cleanser.
3..
4..
Rinse.with.clean.water.
B. Gouges & Cracks
.Follow.with.compound.and.waxing.as.outlined.in.
procedure.above.
Stress.cracks.and.crazing.are.the.appearance.of.
hairline.cracks.in.the.gel.coat.surface..When.present,.
these problems usually occur in the gel coat finish or
the outer “skin coat” fiberglass laminate. The appear-
ance.of.these.cracks.does.not.pose.a.threat.to.the.
If.the.stain.is.not.removed.by.the.hand.dishwashing.
soap.or.mild.cleanser,.then.the.next.procedure.is.to.
Fiberglass and Hull - Section P
Owner’s Manual Page 0
| Categories | Four Winns Funship Manuals, Four Winns Manuals, Outboard Marine Corporation Manuals |
|---|---|
| Tags | Four Winns Funship 194, Four Winns Funship 204, Four Winns Funship 214, Four Winns Funship 224, Four Winns Funship 234, Four Winns Funship 244, Four Winns Funship 264, Four Winns Funship 274 |
| Model Year | 2006, 2007, 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)