4)
5)
Install lubricant level plug before removing
tube from drain/fill hole. Drain/fill plug can
then be installed without loss of lubricant.
Securely tighten both plugs.
Power Trim and Tilt Fluid Reservoir
Tilt the motor up and engage the tilt support. De-
pending on your model, refer to Power Trim and
Tilt. Remove filler cap and check fluid level. If nec-
essary, add enough Evinrude/Johnson Power Trim/
Tilt and Power Steering Fluid to bring the fluid level
even with the bottom of the fill cap hole when the
unit is at full tilt.
2
1
1
2
1.
2.
Drain/fill plug
Lubricant level plug
IMPORTANT: To avoid insufficient injection of lu-
bricant, check the gear oil level 10 minutes after fill-
ing. If the oil level is low, slowly inject the lubricant
up to the correct level.
1.
2.
Tilt support
Filler cap
IMPORTANT: Correct fluid level must be main-
tained to ensure operation of the impact protection
built into this unit.
Steering System
The installer was instructed to grease the steering
cable ram during installation. Periodic regreasing of
the steering cable ram with Triple-Guard grease is
required. Refer to Engine Maintenance and In-
spection Schedule for lubrication frequency. Refer
to steering system manufacturer’s information
when servicing boat’s steering system.
Lubrication Points
Refer to Engine Maintenance and Inspection
Schedule for lubrication frequency and recom-
mended lubricant.
1
1
1.
Steering, tilt tube
1. Swivel bracket, tilt support
WARNING
Failure to regrease as recommended could
result in steering system corrosion. Corro-
sion can affect steering effort, making oper-
ator control difficult.
Maintenance - 43
| Categories | BRP Brand Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 115 hp, Johnson 140 hp, Johnson 90 hp, Johnson CX4, Johnson PL4, Johnson PX4, Johnson X4 |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)