2005 Four Winns Vista 378 Owners Manual

378
D.   Propellers
3.   Prop Slip
Knowledgeof thepropellerismost  easilygainedthrough
better understanding of the terminology used to refer to
the aspects of propeller size and performance. It should
be noted that the 378  Vista™ is equipped with nibral
propellers.
When traveling through water a propeller is unable to get
a complete bite because of the  fluidity of water.  “Prop
Slip” is usually expressed as a percent of the computed
theoretical speed. Twenty-five to thirty-five percent prop
slip is common for a cruiser-type boat operating at cruis-
ing speed.
1.
Diameter
Changing either diameter or pitch will have an effect on
engine speed and prop slip, and in turn, directly effect the
performance of a boat. The propellers included with each
Four Winns® boat provide the best general performance
based on data obtained from on-the-water testing of that
model. Variations in load, operating conditions, environ-
ment,theindividualengineandhullperformancemayne-
cessitate the purchase and use of another propeller(s).
Diameter is twice  the distance from  the center of the
prop shaft to the extreme  tip of a propeller blade.   In-
creasing or decreasing propeller size will have a direct
bearingontheRPM’sanenginewilldevelop.     Thisisdue
to the greater amount of propeller blade surface in con-
tact with the water. See Figure E4.
Under your normal load conditions, the engines should
turn within the maximum RPM range when at full throttle.
IftheenginesexceedtherecommendedRPM,anincrease
in pitch or diameter is required. If the engine RPM is too
low, a decrease in pitch or diameter is required.
The load carried in a boat will directly affect performance
oftheengine.  If anenginethatisnotdevelopingfullpower,
be sure the engine is properly tuned and load conditions
are those normally experienced, before changing propel-
lers.
NOTICE
For twin engine installations, always check drive
shaft rotation before propeller installation. Aright
hand rotation propeller must be installed on the
starboard propeller shaft.  Similarly, a left hand
propmustbeinstalledontheportpropeller     shaft.
For shipping reasons, the propellers are not factory in-
stalled.  Initial  installation of the propellers will  be per-
formedbythedealerduringpre-deliveryservice.     SeeFig-
ure E5.
Figure  E4:   Propeller  Pitch  & Diameter
2.
Pitch
Pitch is a measure of helix angle, or angle of attack, of
therotatingblade.  Pitchiseasilyunderstoodifoneimag-
ines the propeller rotating through a semisolid such as
butter or gelatin. The distance the propeller will travel in
one revolution is called “Pitch.” Increasing or decreasing
pitch will also have  a direct bearing on engine RPM’s
because of the greater bite taken by the blade with each
rotation. See Figure E4.
378 Vista™  Owner’s Manual
Section E
Page5
Product Specification
CategoriesFour Winns Manuals, Four Winns Vista Manuals, Outboard Marine Corporation Manuals
Tags
Model Year2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 201 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandBoats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx
Document File TypePDF
Publisherfourwinns.com
Wikipedia's PageOutboard Marine Corporation
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website