Volvo Penta MD5A Instruction Manual

LAYING-UP AND LAUNCHING
Screw tight the cover with its gasket on the cooling water pump.
Connect the hose between the cooling water intake  and the
reverse gear. Check-tighten all the hose clamps.
Close the drain cocks.
Clean the outside of the engine and the reverse gear.
15
16
Install the battery, which should be fully charged. Grease  the
cable shoes. Connect up the battery cables. IMPORTANT! Do
not mix up the polarity. Tighten up the cable shoes well.
Remove the injector. Take measures to avoid oil splash  and run
the engine several turns so that the oil on the piston crowns is
blown out.
Fit the injector. See under “Tightening torques”, “Technical
Data”.
17
18
Launch the boat. Change the fuel-filter cartridge. Pump forward
the fuel and vent the system. See under “Venting the fuel
system”.
Start the engine. See the instructions on page 5. Run the
engine warm with the reverse gear engaged. Check to make
sure there is no leakage of fuel, air, water or exhaust gases .
Check that all the controls, etc., are functioning properly.
19
If necessary, contact authorized Volvo Penta service shops  and
let them service the engine and reverse gear according to the
instructions in the servicing scheme.
20
23
Product Specification
CategoriesVolvo Penta Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 35 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website