Volvo Penta MD5A Instruction Manual

RUNNING INSTRUCTIONS
Reduce to idle and check that the engine is running smoothly.
Engage the control lever for gear-changing as follows:
Push in the red  disengaging button and pull the  lever back to
neutral.  Release the  button.  The  control lever  can  now  be
used both for gear-changing and enginespeed.
RUNNING
The single lever control has both engine speed and
manoeuvering functions.
F = Forward
R = Reverse
N = Neutral
T = Engine speed control
To achieve good running economy, the engine should not be
run at max. speed for a longer period.
Make sure that the battery charging warning lamp does not
light when the engine is running The siren will sound  and the
respective warning lamp go on if the engine temperature
becomes excessive or the oil pressure too low.
SHUTDOWN PROCEDURE
After shutdown  the  engine  should be  allowed to  idle  for a
couple of minutes or so with the control lever in neutral.
Stop  the engine  by  pulling  out  the  stop control  when  the
engine  is idling.  Then  turn back  the  key switch  to  the initial
position.
Switch off the main switch. NOTE. This switch must never
be switched off until the engine has stopped.
Close the fuel and cooling water cocks if the boat  is not going
to be used for some time.
Check for leakage before leaving the beat.
In  cold  weather  and  whenever  there  is  risk  of  icing,  the
cooling water should  he drained from  the engine and reverse
gear. See under “Laying-up and launching”.
6
Product Specification
CategoriesVolvo Penta Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 35 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website