2011 Four Winns V475 Boat Owners Manual

Remember that it is easier to control a boat in reverse
because a boat steers from the stern. When backing
into a slip, back so that bow swings into the wind if
possible. You will have more control.
An eye splice at the end of each line works well with
bow or stern cleats.
The mooring lines you will use most often are the bow
line, the stern line, and spring lines as shown on
Figure S3. Each line has a specific purpose. The bow
line and the stern line secure your boat’s bow and
stern. The two spring lines keep your boat from
moving forward or backward when you are moored
alongside a dock.
If possible, come in against the wind or current,
whichever is stronger. Approach the dock at a 30-45°
angle. As the boat nears the dock, slowly swing
parallel to it. Tie the bow line first; then the stern.
If wind or current is moving toward the dock, move
parallel to the dock further out. Let the wind or current
push you in. Tie the stern first, then the bow.
If you are mooring your boat for a short time, bow and
stern lines may be the only lines you will need. If you
are mooring your boat for a longer time or the currents
are swift, you should use spring lines. The stern spring
line leads from the boat’s stern cleat forward to the
piling or cleat on the dock. The bow spring line leads
from the bow cleat aft to the dock.
Use extreme caution if wind or current is from your
stern. Back in towards the dock slowly at a slight
angle with engine in slow reverse. Gently swing
parallel. Tie stern first, then the bow.
If you are mooring your boat in a slip, bow and spring
lines, port and starboard, will keep your boat in
position.
If the weather looks bad, use spring-lines from the
bow and stern to dock amidships of the boat. Tie up
on the downwind side of the dock. If the wind is
changeable, place fenders over the side between the
boat and the dock.
B.   Mooring
After you have positioned your boat next to the dock,
you must secure it with mooring lines to keep it in
position. Mooring lines must be long enough to secure
your boat in any docking situation.
For example, dock lines should be at least 2/3 of the
length of your boat and the spring lines should be at
least the full length of your boat. The size (diameter)
of your line depends on the size and weight of your
boat. The following is an approximate guide. See your
Four Winns dealer for recommendations.
Line Diameter
Boats under 20 feet =
Boats 20 to 30 feet =
Boats 30 to 40 feet =
Boats 40 to 60 feet =
Boats over 60 feet =  
3/8”
1/2”
5/8”
3/4”
1”
Note: If your boat is heavy for its size, consider going
up one size in diameter.
Pre-Launch and Underway - Section S
Owner’s Manual Page 168
Product Specification
CategoriesFour Winns Manuals, Four Winns V-Series Manuals
Tags
Model Year2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 189 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandBoats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx
Document File TypePDF
Publisherfourwinns.com
Wikipedia's PageOutboard Marine Corporation
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website