Figure Q4: Port Lounge Table
Figure Q5: Galley Countertop
Before teak can be given any coating, it must be
completely clean. Follow the manufacturer’s directions
with regard to cleaning. Once cleaning has been
accomplished there are finishes that may be applied
such as teak oil (traditional), sealers, or varnishing.
Again, Four Winns recommends following the table
manufacturer recommendations. Additional note:
There are numerous teak products on the market that
may be tried that will give you the look you desire.
Your Four Winns dealer can also provide you with
some helpful suggestions.
NOTICE
Figure Q6: Cockpit Refreshment Center
DO NOT use abrasive cleaners or solvents on
cockpit table. DO NOT use Soft Scrub™ soap
or similar cleaning products; they will scratch
the surface and remove the shine.
NOTICE
DO NOT use tables as a cutting board. The
knife will leave gouges/marks in the surface of
the table. Use an actual cutting board in order
to protect the tables.
Q - 6 SOLID SURFACE MATERIAL
Figure Q7: Port Lounge Aft Countertop
Solid surface material is utilized in the various coun-
tertops found in the galley, cockpit refreshment center,
port lounge, and heads. The solid surface gives these
countertops a rich look and makes for an extremely
strong yet lightweight top. It can be cleaned with hand
dish washing soap and water. Always read the label
before using any product. See Figures Q5 - Q9.
Figure Q8: Aft Head Countertop
Woodwork and Composites - Section Q
Owner’s Manual Page 150
| Categories | Four Winns Manuals, Four Winns V-Series Manuals |
|---|---|
| Tags | Four Winns V475 |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)