NOTICE
EQUIPMENT
Air Conditioners
Battery Chargers
Blankets (Electric)
Coffee Makers
Electrical Drills
Fans
ELECTRICAL LOADS
See motor load plate
DO NOT supply electrical power to an empty
water heater. Activate the FRESH WATER
switch to start the water pump and prime the
system. Be sure there is adequate water in the
system before turning on the water heater.
Failure to comply will result in immediate
damage to the heater element.
Up to 800 watts (7.3 amps)
50 to 200 watts (2 amps)
550 to 700 watts (6.3 amps)
See motor load plate
25 to 75 watts (0.7 amps
1350 watts (12.3 amps)
1500 watts (13.7 amps)
Wattage as marked
Fry Pan
Heater
Electric Stove - The RANGE circuit breaker must be
activated while the boat connected to dockside power
or use the generator (if applicable) to supply power to
the electric stove. Refer to Section L-1A - Galley
Equipment in this manual for more information.
Lights
Television
1500 watts (10.5 amps)
See motor load plate
Vacuum Cleaners
Table III: Electrical Equipment
Water Heater - The WATER HEATER circuit breaker
supplies power to the water heater. Refer to Section
J-2C - Water Heating Systems in this manual for more
information.
C. Reverse Polarity Indicator
Improper grounds or reversed polarity at shore power
are a source of serious electrical hazard. The reverse
polarity light will indicate if a problem exists at the 120
AC electrical system shore connection.
Panel Lights - The PANEL LIGHTS circuit breaker
supply power to the lighting system.
If a problem exists, the reverse polarity indicator light
will come on when the shore power cable is attached
to the inlet. DO NOT activate the SHORE POWER
switch in the cabin when the reverse polarity light is
on.
Microwave - The MICROWAVE breaker must be
activated while the boat connected to dockside power
or use the generator (if applicable) to supply power to
the microwave.
Air Conditioner (Optional) - The AIR CONDITIONER
circuit breaker must be activated while the boat
connected to dockside power or use the generator (if
applicable) to supply power to the air conditioner.
Refer to Section L-4 - Air Conditioning in this manual
for more information.
ALWAYS check the reverse polarity indicator
light in the AC distribution panel immediately
upon connecting the shore power cord before
turning on the AC SHORE POWER circuit
breaker. If the light is on, a problem with a
reversed electrical connection exists.
Disconnect the shore power cord immediately.
Notify the marina and have the dock’s shore
power connection inspected.
Receptacles - The OUTLETS circuit breaker supply
power to the corresponding receptacles in the AC
system.
Most receptacle circuits are capable of handling 15
amperes. Refer to Table III for a list of equipment and
the electrical currents usually required to operate
these items. For 220 volt, 50 Hertz models, divide all
of the current ratings by 2. Usually, the power require-
Under proper operating conditions, the reverse
polarity indicator light will not be on. A green light is
provided for the shore power and will be “ON” when
ment is specified on the electrical item. This is only an dockside power is being used.
approximation of the electric current usage normally
experienced.
NOTICE
Some marina shore power systems may be
improperly grounded to retard electrolysis
(see Section H-11 - Stray Current Corrosion).
Before using any 120 volt equipment, make
sure the reverse polarity light does not activate
when connecting the cord to the inlet.
Electrical Systems - Section H
Owner’s Manual Page 78
| Categories | Four Winns Manuals, Four Winns V-Series Manuals |
|---|---|
| Tags | Four Winns V265, Four Winns V285 |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)