Maintenance
Winterization is complete when outboard Winterization is complete when outboard
shuts itself off.
shuts itself off.
•
If the outboard DOES NOT shut itself • If the outboard DOES NOT shut itself
off, you may not have used the fast idle le- off, you may not have properly advanced
ver or button and the outboard was shifted
into gear.
throttle grip.
If the engine exceeds 3000 RPM, the out-
•
•
If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
board may have been shifted into gear.
In either event, immediately press STOP
button to turn outboard OFF and re-start the
procedure.
In either event, immediately turn key switch
OFF and re-start the procedure.
Tiller Control Outboards
After Winterization – All Outboards
1)
Advance throttle grip to HALF THROTTLE
position. Start the outboard. Outboard runs
at slow idle speed.
1)
After the outboard shuts itself off, turn key
switch OFF. (For tiller models, remove
emergency stop clip / key switch.) Do not
start the outboard again after winterization
is completed.
2)
If winterizing on a trailer, turn off water
and detach garden hose. Grease propeller
shaft splines with recommended lubricant,
and re-install propeller.
NOTICE
When winterizing is finished,
leave the outboard in vertical position
long enough to completely drain the pow-
Tiller Control – Typical
erhead.
If
equipped,
disconnect
the
2)
After outboard runs for about 15 seconds,
move throttle grip to IDLE position. Out-
board continues to run at slow idle speed.
speedometer pickup at the upper connec-
tion and blow all water out of the hose
using air pressure of 25 psi or less.
Reconnect speedometer pickup after all
the water has been removed.
3)
Top off oil tank.
Extra engine oil is used during the winteriza-
tion procedure. Some excess oil may appear
on the skeg below the gearcase area. This is
normal.
3)
4)
After outboard runs for another 15 sec- Avoid potential oil stains by placing a shop
onds, advance throttle grip to HALF
towel or suitable container under the propel-
THROTTLE position. Outboard will accel- ler and skeg for the duration of the storage.
erate to fast idle speed and fog itself.
Allow outboard to run until it shuts itself
OFF automatically (less than one minute).
58
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude PL, Evinrude RL, Evinrude SL, Evinrude TL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)