Using Your Evinrude E-TEC Outboard
After Engine Starts
EMERGENCY STARTING
Check the water pump indicator. A steady (TILLER AND REMOTE ELECTRIC)
stream of water indicates the water pump is
- TL, PL AND SL MODELS
working. If a steady stream of water from the
water pump indicator is not visible, stop the If the starter fails, your engine can be started
engine. Refer to Engine Overheating on using a 1/4 in (6 mm) cord about 4 ft. (1.2 m)
page 46.
long.
WARNING
Move the shift lever to NEUTRAL
before performing emergency start-
ing procedures. Failure to do so
may result in unexpected boat
movement.
The engine cover is a machinery
guard. To prevent injury from mov-
keep
hands, clothes, and hair clear of
powerhead.
ing
engine
components,
Prevent electric shock by keeping
clear of the ignition coils and spark
plug leads when the outboard is
Engine Stopping
Move control handle to NEUTRAL.
Turn key switch counterclockwise to the OFF being started or is running. Shock
position.
can cause serious personal injury
under certain conditions.
OFF
DO NOT turn flywheel by hand. Use
starter cord only.
1
ON
Be sure:
•
•
•
Key switch is OFF.
Engine is in normal operating position.
Shift lever is in NEUTRAL.
Release port and starboard side engine
cover latches downward. Pull up on the tilt
handle to release the engine cover seal
and remove the engine cover.
KEY
START
1)
007072
1.
Key switch, OFF position
Remove the key when the boat will be unat-
tended. If equipped, close the vent screw on
the fuel tank’s filler cap.
1
2
1.
2.
Engine cover latch
Tilt handle
32
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude PL, Evinrude RL, Evinrude SL, Evinrude TL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)