2010 Evinrude 200 225 250 300 hp E-TEC HSL HVL HL HX PL PX PZ CX CZ Outboard Boat Owners Manual

PRODUCT INFORMATION
WATER PRESSURE
WARNING
An  optional  water  pressure  gauge  is  recommended  to
monitor cooling system pressures. Noticing changes in wa-
ter pressure can help prevent engine overheating. The wa-
ter pressure gauge must be connected at the correct point
to ensure the most accurate pressure readings. Follow the
installation instructions  included  with  the  water  pressure
gauge.
Keep the battery connections clean, tight, and insu-
lated to prevent their shorting or arcing and causing
an explosion.  If the  battery mounting  system does
not  cover  the  connections,  install  covers.   Check
often to see that connections stay clean and tight.
1
1.
Water pressure port (starboard)
IMPORTANT: DO NOT use wing nuts on battery connec-
tions even if they came with the battery. Wing nuts can
loosen and cause errant warning signals or electrical sys-
tem damage.
Service
Before servicing the battery or the outboard, remove both
battery cables from the battery, battery negative (–) cable
first.  Keep  metal  objects  from  contacting  either  battery
post.
IMPORTANT:  Service  electrical  components  only  while
the outboard is  NOT running. Be careful when identifying
positive and negative battery cables and posts.
WARNING
Battery electrolyte is acidic — handle with care. If
electrolyte  contacts  any  part  of  the  body,  immedi-
ately flush with water and seek medical attention.
Do not use a booster battery and jumper cables to
start the outboard. Gasoline fumes can cause explo-
sion  and  fire,  resulting  in  property  damage,  per-
sonal injury or death.
ACCESSORY BATTERY CONNECTION
An optional accessory battery charge kit is available to al-
low the charging system to charge the cranking and acces-
sory batteries at the same time. See your Dealer to order
and install this kit (P/N 5006253).
IMPORTANT: The accessory battery connection must only
be used to charge a single 12-volt battery or two 12-volt
batteries wired in parallel. The accessory connection must
not be used to charge either battery in a 24-volt system.
48
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , , , , , , , , , ,
Model Year2010
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 72 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website