Chapter 6: Plumbing
Bilge Pump Testing
•
•
The bilge pump is vital to the safety of your boat.
Test the bilge pump often.
1.
2.
•
Turn On the bilge pump switch at the helm.
Make sure that water in the bilge is pumped overboard.
If there is water in the bilge and the pump motor is running but not pumping, inspect the discharge hose for a kink
or collapsed area.
•
If the discharge hose looks okay, check the bilge pump housing for clogging debris (see below).
Checking for clogging debris:
1.
2.
Remove the pump motor from the
housing:
a. Lift the tab while rotating the
fins counter-clockwise.
b. Lift out the pump motor.
c. Clear the housing of debris.
Reinstall the pump motor:
PUMP
MOTOR
TAB
"O" RING
HOUSING
a. Make sure the "O" ring is prop-
erly seated.
b. Coat the "O" ring with a light
film of vegetable or mineral oil.
c. Align the cams on either side of
the pump motor with the slots
on the housing.
FIN
CAM (TYPICAL
OPPOSITE SIDE)
SLOT (TYPICAL
OPPOSITE SIDE)
d. Press the pump motor into the housing while twisting clockwise.
3.
Check the reinstallation by trying to twist the fins counter-clockwise without lifting the tab; the pump motor
should stay in place.
29
| Categories | Maxum Manuals |
|---|---|
| Tags | Maxum 2400SC3 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)