Product Information
Installation
WATER PRESSURE
Slide thrust washer onto shaft with shoulder An optional water pressure gauge is recom-
facing aft.
Slide propeller onto shaft, engaging the
splines and seating it on the thrust bushing.
Slide spacer onto the shaft and engage the
propeller shaft splines.
Wedge a block of wood between the propeller included with the water pressure gauge.
blade and the anti-ventilation plate.
mended to monitor cooling system pressures.
Noticing changes in water pressure can help
prevent engine overheating. The water pres-
sure gauge must be connected at the correct
point to ensure the most accurate pressure
readings. Follow the installation instructions
Install propeller nut and tighten to a torque of
1
120-144
in. lbs. (13.6-16.3 N·m).
2
Install keeper on propeller nut, align keeper
slots and cotter pin hole.
Install new cotter pin and bend ends to se-
cure.
Remove block of wood. Make sure engine is
in NEUTRAL; give propeller a spin. It must
turn freely.
1.
2.
Water pressure port (behind fuel filter)
Fuel filter
Repair
If your propeller hits a solid object, the impact
is partially absorbed by the rubber bushing in
the hub to help prevent damage to the out-
board. A strong impact can damage the hub
and propeller blades. Damage to blades can
cause unusual and excessive vibration. Dam-
age to the hub can cause excessive engine
RPM with little forward movement.
IMPORTANT: Avoid or limit operation using a
damaged propeller. Carry a spare propeller.
Keep your propeller in good condition. Use a
file to smooth slight damage to blade edges.
See your Dealer for repair of serious damage.
60
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude RT, Evinrude SL, Evinrude TL |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)