Using Your E-TEC Outboard
After Engine Starts
EMERGENCY STARTING
Check the water pump indicator. A steady (TILLER AND REMOTE ELECTRIC)
stream of water indicates the water pump is
- TL, PL AND SL MODELS
working. If a steady stream of water from the
water pump indicator is not visible, stop the If the starter fails, your engine can be started
engine. Refer to Engine Overheating on using a 1/4 in (6 mm) cord about 4 ft. (1.2 m)
page 41.
long.
WARNING
Move
the shift lever to NEUTRAL
before performing emergency starting
procedures. Failure to do so may result
in unexpected boat movement.
The engine cover is a machinery guard.
To prevent injury from moving engine
components, keep hands, clothes, and
hair clear of powerhead.
Prevent electric shock by keeping clear
of the ignition coils and spark plug
leads when the outboard is being
started or is running. Shock can cause
serious personal injury under certain
conditions.
Engine Stopping
Move control handle to NEUTRAL.
Turn key switch counterclockwise to the OFF
position.
DO NOT turn flywheel by hand. Use
starter cord only.
IMPORTANT: Be sure to turn key OFF when
outboard is not in use to avoid discharging the
battery.
Be sure:
Key switch is OFF.
•
Remove the key when the boat will be unat- • Engine is in normal operating position.
tended
• Shift lever is in NEUTRAL.
1)
Release port and starboard side engine
cover latches downward. Pull up on the tilt
handle to release the engine cover seal
and remove the engine cover.
1
2
1.
2.
Engine cover latch
Tilt handle
28
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude RT, Evinrude SL, Evinrude TL |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)