X INSTALLATION
Use the supplied Transom Mounting Kit to se-
curely mount the outboard. The kit includes a
transom mounting plate and hardware for fas-
tening outboard to transom.
WARNING
The
outboard
must
be
correctly
installed. Failure to correctly install the
outboard could result in serious injury,
death or property damage. We strongly
recommend that your Dealer install
your outboard to ensure proper instal-
lation.
2
1
2
IMPORTANT: Follow all directions carefully.
The outboard’s warranty will not cover prod-
uct damage or failure that results from incor-
rect outboard installation.
3
WARNING
1.
2.
3.
Transom plate
Small washers
Large washers
Even if equipped with clamp screws,
your outboard must be bolted to the
boat to prevent it from “working off the
transom” during operation.
The kit also includes clamp pads, which must
be used to secure mounting bolts in slots at
the bottom of the outboard stern brackets.
Center the outboard on the transom (or
mounting bracket) and tighten clamp screws
by hand.
Use the outboard stern brackets as a tem-
plate for location and size of holes to drill in
the transom.
Use each stern bracket’s mounting holes as a
guide to drill four 11/32 in. (8.7 mm) holes
through the transom.
1
1.
Clamp pad
Install the mounting bolts through the stern
brackets and transom. Install round backing
plates and locknuts onto bolts and tighten se-
curely.
1
1
WARNING
When replacing bolts, screws, or other
fasteners, use Evinrude/Johnson parts
or parts of equivalent strength and
material.
1.
Drilled transom holes
39
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 65 hp, Evinrude WRL, Evinrude WRY |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)