Using Your E-TEC Outboard
Alcohol Fuels
IMPORTANT: Fuel distribution hoses in the
boat must deliver fuel at the rate of flow need-
ed by the outboard. Minimum inside diameter
of fuel hoses must be 3/8 in. (9 mm).
Your outboard has been designed to operate
using the specified fuels; however, be aware
of the following:
Fuel systems with built-in tanks, particularly
those that include antisiphon valves and filter/
primer units, may have restrictions not allow-
ing the engine fuel pump to deliver sufficient
fuel under all conditions. This can result in a
loss of performance. If a performance prob-
lem exists, see your Dealer.
•
•
•
The boat’s fuel system may have different
requirements regarding the use of alcohol
fuels. Refer to the boat’s owner guide.
Alcohol attracts and holds moisture that can
cause corrosion of metallic parts in the fuel
system.
Alcohol blended fuel may cause engine per-
formance problems.
FUEL SYSTEM PRIMING
Using alcohol-extended fuels is acceptable
ONLY if the alcohol content does not exceed:
•
•
10% ethanol by volume; or
5% methanol with 5% cosolvents by volume.
If the outboard is run out of fuel, refill the fuel
tank and squeeze the primer bulb until firm.
Prime the electric fuel pump by first removing
the emergency stop switch clip and then pull-
ing the rope at least two times. This will cause
the fuel pump to fill the injectors. Replace the
emergency stop switch clip and follow the
If the fuel hose is disconnected for any rea- normal starting procedure.
son, seal it to prevent spillage. Cap the fuel
fitting to prevent contamination.
FUEL SYSTEM OPERATION
Connecting the Fuel Hose
1)
2)
Connect the fuel hose to the 3/8 in. (9 mm) FUEL ADDITIVES
fuel fitting. Fasten hose securely with
clamp (18.5 mm) from owner’s kit.
The only fuel additives approved for use in
your Evinrude E-TEC outboard are:
•
•
Evinrude/Johnson 2+4 Fuel Conditioner
Evinrude/Johnson Fuel System Cleaner
Use of other fuel additives can result in
poor performance or engine damage.
1
Evinrude/Johnson 2+4 Fuel Conditioner will
help prevent gum and varnish deposits from
forming in fuel system components and will
remove moisture from the fuel system. It can
be used continuously and should be used
during any period when the outboard is not
being operated on a regular basis. Its use will
reduce spark plug fouling, fuel system icing,
and fuel system component deterioration.
1.
Fuel hose and fitting – 3/8 in. (9 mm)
Evinrude/Johnson Fuel System Cleaner will
help keep fuel injectors in optimal operating
condition.
WARNING
Store fuel tanks in a well-ventilated
area, away from heat and open flame.
Prevent escape of liquid or vapors
which could accidentally ignite.
Close the filler cap vent screw, if
equipped.
Be sure the disconnected fuel hose
does not drip.
16
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 65 hp, Evinrude WRL, Evinrude WRY |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)