Engage
MOORING
Move tilt/run lever to the TILT position.
You may moor your boat with the motor’s gearcase
out of the water by using its tilt feature. Depending
on the model, refer to Tilting and Tilt Support.
1
2
FLUSHING
DANGER
DO NOT run the engine indoors or without
adequate ventilation or permit exhaust
fumes to accumulate in confined areas.
Engine exhaust contains carbon monoxide
which, if inhaled, can cause serious brain
damage or death.
1.
2.
Tilt/run lever – TILT position
NEUTRAL
See your Dealer for a flushing device designed to fit
your engine. Follow manufacturer’s instructions for
installing and using it.
Grasp tilt grip on engine cover and tilt motor half-
way.
Shallow-water drive bracket will automatically en-
gage.
WARNING
Slowly, lower motor until shallow-water drive brack-
ets rests against angle adjusting rod.
Prevent injury from contact with rotating
propeller; remove the propeller before
flushing.
IMPORTANT: Check often that water intakes are
completely submerged and the water pump indica-
tor is discharging a steady stream of water.
Disengage
Outboard — Running
Move tilt/run lever to the RUN position.
1)
Place the engine in vertical position in a well-
ventilated area with good drainage.
2)
3)
Install flushing device and garden hose.
Cover the water intake hole with tape.
2
1
1
1.
Tape
1.
2.
Tilt/run lever – RUN position
NEUTRAL
Grasp tilt grip on engine cover and tilt motor slightly.
Shallow-water drive bracket will automatically re-
lease.
Slowly, lower motor to normal operating position.
26
- Operation
| Categories | BRP Brand Manuals, Johnson 4-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Johnson 30 hp, Johnson TEL4 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Publisher | johnson.com |
| Wikipedia's Page | Johnson Outboards |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)