If the electric starter fails or the battery’s voltage is
too low to power the starter, use the cord from the
tool kit and these instructions to start your engine
manually.
Turn the key switch to the ON position ONLY, listen
carefully for the electric fuel pump to cycle.
While seated, pull the starter cord quickly and com-
pletely. The first pull is needed to energize the elec-
trical system. Rewind the starter cord and pull
again. Repeat as needed until the engine starts.
IMPORTANT: The battery must have enough re-
serve voltage to activate the electric pump or the
engine will not start using the emergency starting
procedures. Do your best to determine battery sta-
tus by listening for the electric fuel pump audible cy-
cle before continuing the emergency starting
procedures. The electric fuel pump cycles each
time the key switch is turned from OFF to ON.
Place key switch in OFF position with the motor in
normal operating position. Refer to Power Trim
and Tilt.
Move the control handle to NEUTRAL, then remove
engine cover.
1
Loosen the lock nut. Remove the cable from the
bracket. Separate end of cable from the cam.
1.
NEUTRAL
If your engine’s electrical system is functional, the
alternator should charge the battery once the en-
gine is running. If it is not, the engine will quit run-
ning once the battery voltage is too low to power the
electrical components.
1
DO NOT attempt to replace the flywheel cover or
the engine cover while the engine is running.
Snap lanyard to secure place on clothing and pro-
ceed to the nearest landing for service.
2
FUEL ECONOMY
1.
2.
Locknut
Cam
The economy throttle range can save fuel, depend-
ing on boat load and hull design. When boat reach-
es top speed, throttle back from FULL SPEED to
the economy throttle range. You will save fuel with-
out a noticeable loss of speed.
Remove the three screws securing the manual start-
er. Remove the three screws securing the flywheel
cover.
Tie a knot in one end of the emergency starter cord.
Thread the small bar from the tools kit halfway
through one knot so it forms a handle.
1.
2.
Concealed side mount control
Binnacle mount control
Connect the clip to the emergency stop / key switch.
Place knot of starter cord in notch on flywheel pul-
ley. Wrap cord around pulley clockwise.
24
- Engine Starting
| Categories | Johnson 4-Stroke Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 30 hp, Johnson PL4 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)