Move tilt/run lever to RUN position. Place motor in
its normal operating position.
Using a screwdriver, compress one of the two lock-
ing tabs on the starter lockout cable. At the same
time, pull the cable steadily until that tab clears the
housing. Repeat for the other locking tab. Pull the
lockout cable from the starter housing. Secure the
lockout cable in the lower engine cover, away from
moving engine parts.
1
1
1.
RUN position
Be sure:
•
•
•
•
Engine is in normal operating position.
Fuel hose primer bulb is firm.
Shift lever is in NEUTRAL.
1.
Locking tabs
Twist-Grip throttle is at START.
Tie a knot in one end of your emergency starter
cord and hook it in the notch on the flywheel. Wind
the cord clockwise around the starter ridge on the
flywheel.
Pull latch and remove engine cover.
2
2
Remove three screws that secure the manual start-
er and remove starter assembly from engine.
1.
2.
Knot
NEUTRAL
Follow the starting procedures in Start-up (Cold
Engine).
While seated, pull hard on emergency starting cord
to start motor. After the motor starts, run it at less
than 2000 RPM in NEUTRAL for two minutes, then
reduce speed to an idle.
Do not attempt to replace manual starter or engine
cover while engine is running. If equipped, snap
emergency stop switch lanyard to a secure place
on your clothing.
1
Proceed to nearest landing for service.
1.
Screws
Engine Starting - 21
| Categories | BRP Brand Manuals, Johnson 2-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 6 hp, Johnson 8 hp, Johnson R, Johnson RL |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)