OIL
MIXING FUEL AND OIL
Evinrude/Johnson XD25 Formula outboard oil
is recommended for your outboard. It contains a
richer additive package than other TC-W3 oils, min-
imizing carbon build-up and deposits on pistons
and bearing surfaces. It provides 25% greater de-
tergency than minimum TC-W3 requirements.
Evinrude/Johnson brand oils are formulated to give
best engine performance while controlling piston
and combustion chamber deposits, providing supe-
rior lubrication, and ensuring maximum spark plug
life.
Use the following chart and these guidelines to mix
oil with the engine’s fuel.
Fuel
Ratio
50:1
25:1
6 U.S. Gallons
16 fl. oz. oil
3 U.S. Gallons
8 fl. oz. oil
1 Liter
20 ml oil
40 ml oil
32 fl. oz. oil
16 fl. oz. oil
Portable Tank
Above and below 32° F (0° C), add one gallon of fu-
el. Pour in required amount of oil. Add remaining fu-
el. Install filler cap and tip tank gently to distribute
oil.
If Evinrude/Johnson XD25 Formula outboard oil is
not available, you must use an NMMA-certified TC-
W3 oil such as Evinrude/Johnson direct injection oil
or Evinrude biodegradable outboard oil.
IMPORTANT: Failure to follow this recommenda-
tion could void the engine warranty if a lubrication-
related failure occurs.
ADDITIVES
IMPORTANT: Only use fuel additives approved by
BMCA for your outboard. Use of other fuel additives
can result in poor performance or engine damage.
Evinrude/Johnson 2+4® fuel conditioner will
help prevent gum and varnish deposits from form-
ing in fuel system components and will remove
moisture from the fuel system. It can be used con-
tinuously and should be used during any period
when your engine is not being operated on a regu-
lar basis. Its use will reduce spark plug fouling, fuel
system icing, and fuel system component deteriora-
tion.
Permanently Installed Tank
Above 32° F (0° C), pour oil slowly with the fuel as
tank is filled. Below 32° F (0° C), add one gallon of
fuel to a separate container. Pour in required
amount of oil. Install filler cap and tip container gen-
tly to distribute oil. Slowly pour oil/fuel mixture into
tank with fuel as tank is filled.
FUEL/OIL RATIO
New Engine
During break-in, you must use a 25:1 (4% oil) fuel/
oil ratio in your fuel tank. Refer to Break-In (10
Hours).
Normal Operation
After break-in, the engine must be operated at a
50:1 (2% oil) fuel/oil ratio.
High Performance
During high performance operation you must use a
25:1 (4% oil)
fuel/oil ratio in your fuel tank.
Fuel and Oil - 15
| Categories | BRP Brand Manuals, Johnson 2-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 6 hp, Johnson 8 hp, Johnson R, Johnson RL |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)