LAYING-UP AND LAUNCHING
SERVICE IN CONNECTION WITH LAUNCHING
If Volvo Penta diesel engine oil has been used, you only need
to check the oil level in the engine and reverse gear and S-
Drive. If preservative oil has been used, both oil and filter must
be replaced. See under “Service after every 50 hours of
operation”.
14
15
Check the tightening of all hose clamps. Check that all drain-
cocks are closed.
Install the battery or batteries, which must be fully charged.
Grease
the
cable
terminals.
Fit
the
battery
cables.
IMPORTANT! Do not mix the polarity. Tighten up the cable
terminals well.
16
17
Following concerns folding propellers:
Assemble the folding propeller, remove excess grease and
check that the blades are folding easily. Grease the propeller
hub. Check that all the zinc anodes are in good shape. Install
the propeller.
Paint the bottom of the boat with an anti-fouling paint. If the
boat is equipped with the S-Drive model 110S itis important to
check that the anti-fouling paint does not contain copper, which
will cause damage due to corrosion on the S-Drive. Further
paint the S-Drive with the Volvo Penta anti-fouling paint. NOTE!
Do not paint the zinc anodes.
18
Pump up the fuel and vent the fuel system (see page 23).
19
27
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta MD6A 110S, Volvo Penta MD7A |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 3.33 out of 4)
Marine readers have rated Volvo Penta MD7A 110S Owners Manual 3.3 out of 4.0 based on 3 product reviews. I'll let you know when I had a look
I need some info for my engine
please. i need a book of engine md 7 a