Using Your E-TEC Outboard
Move the shift lever to NEUTRAL. Refer to Starting
Grasp tilt grip on engine cover and tilt out-
board to the full tilt position. on page 25.
While seated, grasp the starter handle and
pull slowly until the starter engages, then pull
hard. Repeat, if needed, until outboard starts.
NOTICE
assembly, allow starter cord to rewind be-
fore releasing starter handle.
To prevent damage to starter
1
1
1.
NEUTRAL
WARNING
Always shift to NEUTRAL before
starting the outboard to prevent
sudden boat movement, which can
cause injury.
1. Starter handle
IMPORTANT: Engine will not start if outboard
is in gear or if lanyard is not in place.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 43.
Twist throttle grip to slowest idle position.
After Engine Starts
1
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 29.
007871
1.
Slowest idle position
DO NOT advance the throttle before start-up.
Advancing the throttle overrides the electron-
ic idle control system. After the engine starts,
the engine management module (EMM) au-
tomatically increases idle speed slightly. Idle
speed will decrease as the engine warms up.
22
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 65 hp, Evinrude Commercial, Evinrude WRL, Evinrude WRY |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)