Using Your E-TEC Outboard
Move the shift lever to NEUTRAL. Refer to While seated, grasp the starter handle and
Grasp tilt grip on engine cover and tilt out- pull slowly until the starter engages, then pull
board to the full tilt position. on page 21.
hard. Repeat, if needed, until outboard starts.
To prevent damage to starter assembly, allow
starter cord to rewind before releasing starter
handle.
1
1
1.
NEUTRAL
1.
Starter handle
WARNING
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 36.
Always shift to NEUTRAL before start-
ing the outboard to prevent sudden
movement, which can cause
boat
injury.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 23.
Twist throttle grip to slowest idle position.
1
007007-8
1.
Slowest idle position
DO NOT advance the throttle before start-up.
Advancing the throttle overrides the electron-
ic idle control system. After the engine starts,
the engine management module (EMM) au-
tomatically increases idle speed slightly. Idle
speed will decrease as the engine warms up.
18
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 65 hp, Evinrude Commercial, Evinrude WRL, Evinrude WRY |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)