X RIGGING AND ACCESSORIES
Installation
Installation
Slide thrust washer onto shaft with shoulder Read and understand the safety information
facing aft.
Slide propeller onto shaft, engaging the
splines and seating it on the thrust bushing.
Slide spacer onto the shaft and engage the clean and free of corrosion.
propeller shaft splines.
supplied with your battery BEFORE you begin
installation.
IMPORTANT: Make sure all components are
Connect the RED (+) cable to the positive (+)
Wedge a block of wood between the propeller battery post first. Connect the BLACK (–) ca-
blade and the anti-ventilation plate. ble to the negative (–) battery post last.
Install propeller nut and tighten to a torque of If you have marine battery posts, install each
70-80
Install keeper on propeller nut, align keeper
slots and cotter pin hole.
ft. lbs. (95-109 N·m).
main cable on the clamp adapter with a star-
washer below it. Install all wires from acces-
sories on the threaded portion of the post.
Install new cotter pin and bend ends to se-
cure.
Remove block of wood. Make sure engine is
in NEUTRAL; give propeller a spin. It must
turn freely.
Repair
If your propeller hits a solid object, the impact
is partially absorbed by the rubber bushing in
the hub to help prevent damage to the out-
board. A strong impact can damage the hub
and propeller blades. Damage to blades can
cause unusual and excessive vibration. Dam-
age to the hub can cause excessive engine 1. Main cable
RPM with little forward movement.
2. Starwasher
3.
Accessory wires
IMPORTANT: Avoid or limit operation using a
damaged propeller. Carry a spare propeller.
If you have automotive battery posts, place a
Keep your propeller in good condition. Use a starwasher on the clamp adapter first, then
file to smooth slight damage to blade edges. the main cable, and then the wires from the
See your Dealer for repair of serious damage.
accessories.
BATTERY
Requirements
•
12-volt, heavy-duty, designated for “marine”
use;
•
•
Vented/refillable or maintenance-free; and
Rated according to the minimum require-
ments in Specifications on page 46.
Deep-cycle batteries are suitable IF they
meet or exceed the minimum CCA require-
ments.
Ask your Dealer about your outboard’s re-
quirements before installing longer battery ca-
bles or a battery switch.
1.
2.
3.
Main cable
Starwasher
Accessory wires
Tighten all connections securely and coat the
installation with Triple-Guard grease.
43
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 115 hp, Evinrude 150 hp, Evinrude 175 hp, Evinrude 200 hp, Evinrude BX, Evinrude CX, Evinrude HL, Evinrude PL, Evinrude PX, Evinrude SL |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated 2008 Evinrude 115 150 175 200 hp E-TEC PL PX SL BX HL CX Outboard Motor Owners Manual 5.0 out of 5.0 based on 1 product reviews. I own a 2008 Etec and would like to review the manual.