10-HOUR INSPECTION
IMPORTANT: Provide a water supply to the engine
and start it. Run the engine at idle only.
To run the engine on a flusher, refer to Flushing.
After 10 hours of operation, your new engine will be
broken in and its mechanical parts will have seated.
At that time, all systems should be checked and any
adjustments needed should be made.
Oil — Start the engine and run it at least five min-
utes to warm the crankcase oil.
Stop the engine and drain the crankcase while the
engine is warm. Refill it with Evinrude/Johnson Ul-
tra 4-Stroke synthetic blend oil. Refer to Crankcase
Oil. Restart the engine and run it for a few minutes
to circulate the fresh oil.
Your Dealer will perform this 10-Hour Inspection at
your request and expense (based on local rates),
according to what your engine needs — refer to En-
gine Maintenance and Inspection Schedule, 10-
Hour Inspection for a partial list.
Follow consistent preventive maintenance by hav-
ing your Dealer check and service your engine
once a year or after each 100 hours of operation,
whichever comes first.
IMPORTANT: It is very important that the bearing
surfaces be coated with clean oil before entering a
period of storage, so be sure you run the engine af-
ter changing the oil.
Stop the engine and turn off the water. Disconnect
the flushing device.
OFF-SEASON STORAGE
Spark Plugs — Remove and examine them.
Spray fogging oil into the plug holes. Slowly rotate
the flywheel several rotations by hand to distribute
the oil and to drain the water from the water pump.
Clean and reinstall the spark plugs, or discard and
replace them, if necessary. Refer to Spark Plugs.
You must protect against natural environmental
conditions that can be damaging to an outboard
motor. Temperature and humidity changes while
your outboard motor is not in use can cause corro-
sion of internal engine parts when they are not pro-
tected. Fuel remaining in your fuel tank and in the
engine will oxidize and weather which can result in
loss of octane and can cause gum deposits in the
fuel system. Your warranty does not cover engine
failure caused by these conditions. We strongly rec-
ommend that you have your Dealer prepare your
outboard for the off-season.
Fuel filter(s) — Clean or change.
Ignition, oil, and fuel systems — Check for mis-
placed leads and damaged or deteriorated parts.
Be sure starter solenoid terminal boot and all con-
nectors are in place.
Screws, bolts, nuts — Tighten
loose.
any that are
To do the off-season storage preparations yourself,
gather the supplies and perform the following steps:
2+4
Fuel Conditioner
Triple-Guard® grease
Ultra-HPF gearcase lubricant
Storage Fogging Oil spray can
Evinrude/Johnson Ultra 4-Stroke synthetic
blend oil
Stabilize the engine’s fuel supply with 2+4 Fuel
Conditioner during the last hours of operation to en-
sure proper stabilization, following instructions
on the container for mixture. Be sure to run the
engine long enough for the treated fuel to reach
the engine.
WARNING
Prevent injury from moving engine compo-
nents. Before starting the engine:
Shift it to NEUTRAL.
Keep hands, clothes, and hair clear of pow-
erhead.
Remove the propeller if you use a flushing
device.
32
- Maintenance
| Categories | BRP Brand Manuals, Johnson 4-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 4 hp, Johnson 5 hp, Johnson 6 hp, Johnson R4, Johnson RL4 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
i need johnson 65 hp motor boat engine manual