FLUSHING
Outboard — Running
1)
Place the engine in vertical position in a well-
ventilated area with good drainage.
Remove the plug from the flushing port.
Install flushing device and garden hose.
Cover the water intake hole with tape.
Place the shift lever in NEUTRAL with the
propeller removed.
DANGER
2)
3)
4)
5)
DO NOT run the engine indoors or without
adequate ventilation or permit exhaust
fumes to accumulate in confined areas.
Engine exhaust contains carbon monoxide
which, if inhaled, can cause serious brain
damage or death.
6)
Start the water — keep pressure between 20
to 40 psi (140 to 300 kPa).
2
See your Dealer for a flushing device designed to fit
your engine. Follow manufacturer’s instructions for
installing and using it.
1
WARNING
Prevent injury from contact with rotating
propeller; remove the propeller before
flushing.
1.
2.
Flushing device
Tape
7)
Start the engine — run it at idle only and
flush it for at least five minutes.
8)
9)
Shut OFF the engine, then turn off the water.
Remove the tape and reinstall the flushing
port.
10)
Leave the outboard in vertical position long
enough to completely drain the powerhead.
26
- Operation
| Categories | BRP Brand Manuals, Johnson 4-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 4 hp, Johnson 5 hp, Johnson 6 hp, Johnson R4, Johnson RL4 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
i need johnson 65 hp motor boat engine manual