ENGINE OVERHEATING
If the stream from the water pump indicator be-
comes intermittent or stops, reduce speed to idle
and:
IMPORTANT: Do not run your engine — even for a
brief start-up — without supplying water to it. Refer
to Flushing.
Shift to NEUTRAL;
SHUT OFF the engine;
While boating, the engine’s water intake must stay
completely submerged and unobstructed. Observe
proper transom height and trim angle. While the en-
gine is running, the engine’s water pump indicator
must discharge a steady stream of water. Check
the indicator often, especially when operating in
weeds, muddy and debris-laden water, at extreme
trim angles, or in shallow water drive (if equipped).
Tilt the motor up;
Clean the intake screen of any blockage;
Clean the water pump indicator of any blockage;
Lower the motor; and
Restart the engine and run at idle.
IF cleaning the screen and indicator does not re-
store the water pump indicator’s steady discharge,
SHUT OFF the engine and do not attempt to oper-
ate it. See your Dealer.
IF cleaning the screen and indicator does restore
the water pump indicator’s steady discharge, con-
tinue to idle the engine until it cools.
IMPORTANT: You must restore cooling to the en-
gine to avoid serious engine damage.
1
After any overheat, have your Dealer:
Torque the cylinder head screws.
Inspect the water pump for excessive wear or dam-
age.
1.
Water pump indicator
Inspect the thermostats.
Inspect the engine for leaks.
Check engine oil level.
24
- Operation
| Categories | BRP Brand Manuals, Johnson 4-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Johnson 2.5 hp, Johnson R4 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Publisher | johnson.com |
| Wikipedia's Page | Johnson Outboards |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)