MOTOR ANGLE ADJUSTMENT
Tighten the wing nut and replace the thread sleeve.
The engine should be perpendicular to the water
when the boat is underway at full speed. This ad-
justment can only be determined by water testing
the boat. Set angle adjustment for your normal
load.
With the engine shut OFF, tilt the motor fully and
push in the tilt lock pin. Refer to Tilting.
1
2
1.
2.
Thread sleeve
Wing nut
IMPORTANT: Be sure the thread sleeve is in place
to prevent possible loss of the wing nut by vibration.
If needed, an extra sleeve is enclosed with the Op-
erator’s Guide.
Pull the tilt lock pin and gently lower the motor until
it rests against the angle adjustment bolt.
Carefully remove the thread sleeve from the angle
adjustment bolt and loosen the wing nut.
SHALLOW-WATER DRIVE
Slide the adjustment bolt to the desired position.
When operating in shallow water, move the angle
adjustment bolt to the outermost position so the
gearcase is farthest from the boat and highest in the
water. Operate at slow speed only.
Operation - 21
| Categories | Johnson 2-Stroke Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 3.5 hp, Johnson R |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)