Engage
FLUSHING
Move tilt/run lever to the TILT position.
DANGER
2
DO NOT run the engine indoors or without
adequate ventilation or permit exhaust
fumes to accumulate in confined areas.
Engine exhaust contains carbon monoxide
which, if inhaled, can cause serious brain
damage or death.
1
See your Dealer for a flushing device designed to fit
your engine. Follow manufacturer’s instructions for
installing and using it.
1.
2.
Tilt/run lever – TILT position
NEUTRAL
Grasp tilt grip on engine cover and tilt motor half-
way.
WARNING
Prevent injury from contact with rotating
propeller; remove the propeller before
flushing.
Shallow-water drive bracket will automatically en-
gage.
Slowly, lower motor until shallow-water drive brack-
ets rests against angle adjusting rod.
IMPORTANT: Check often that water intakes are
completely submerged and the water pump indica-
tor is discharging a steady stream of water.
Outboard — Running
1)
Place the engine in vertical position in a well-
ventilated area with good drainage.
2)
3)
Install flushing device and garden hose.
Cover the water intake hole with tape.
Disengage
Move tilt/run lever to the RUN position.
2
1
1
1.
4)
5)
Tape
Place the shift lever in NEUTRAL with the
propeller removed.
Start the water — keep pressure between 20
to 40 psi (140 to 300 kPa).
1.
2.
Tilt/run lever – RUN position
NEUTRAL
Grasp tilt grip on engine cover and tilt motor slightly.
Shallow-water drive bracket will automatically re-
lease.
Slowly, lower motor to normal operating position.
MOORING
1
You may moor your boat with the motor’s gearcase
out of the water by using its tilt feature. Depending
on the model, refer to Tilting and Tilt Support.
1.
Flushing device
Operation - 27
| Categories | Johnson 4-Stroke Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 25 hp, Johnson E4, Johnson EL4 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)