X
TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE
Starter motor will not operate
• Shift handle not in NEUTRAL.
•
•
Fuse blown. Refer to Fuse on page 30.
Battery is dead.
Engine will not start
• Not following starting instructions. Refer to Start-
ing, Stopping, Shifting on page 14.
•
•
•
•
•
•
Fuel tank empty.
Fuel hose kinked.
Fuel system contaminated with water or dirt.
Fuel filter obstructed.
Throttle not at IDLE. Return throttle to IDLE.
Spark plugs incorrect. Refer to Specifications on
page 46.
Spark plugs improperly gapped, carboned,
burned, or wet.
Fuse blown. Refer to Fuse on page 30.
Flashing “Water Temp” or hot light, refer to En-
gine Monitoring on page 20 and Engine Over-
heating on page 22.
•
•
•
•
Flashing “Check Engine” or “Chk Eng” light, refer
to Engine Monitoring on page 20.
Engine will not idle properly
Engine loses power
• Debris on propeller.
•
Spark plugs damaged or incorrect. Refer to
Specifications on page 46.
•
Fuel system contaminated with water or dirt.
• Spark plugs damaged or incorrect. Refer to
Specifications on page 46.
•
•
•
Fuel filter obstructed.
Fuel system contaminated with water or dirt.
Water intakes obstructed and cooling system not
operating correctly. Refer to Engine Overheating
on page 22.
Oiling system malfunction.
S.A.F.E. protection mode activated. Refer to En-
gine Monitoring on page 20.
•
•
Engine runs, but makes little or
no progress
• Propeller hub loose, slipping.
• Propeller blades bent or missing.
•
•
Propeller shaft bent.
Propeller debris.
Warning system activates
• Refer to Engine Monitoring on page 20.
39
| Categories | Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 200 hp, Evinrude 225 hp, Evinrude 250 hp, Evinrude CX, Evinrude CZ, Evinrude HL, Evinrude PL, Evinrude PX, Evinrude PZ, Evinrude SL |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)