2011 Evinrude 65 hp E-TEC WRL WRY Outboard Boat Motor Owners Manual

X STORAGE
1)
2)
Stabilize the engine’s fuel supply. Add 2+4
Fuel Conditioner  following instructions  on
container. Fill fuel tank.
Winterization  is   complete  when  outboard
shuts itself off.
If  the outboard  DOES  NOT  shut itself
off, you may  not have properly  advanced
throttle grip.
If winterizing on a trailer, remove the pro-
peller.  Attach  a garden  hose  to  flushing
port and turn on the water. Refer to Flush-
ing on page 38.
•  If the engine exceeds 3000 RPM, the out-
board may have been shifted into gear.
In  either  event,  immediately  press   STOP
button to turn outboard OFF and re-start the
procedure.
3)
Outboard must be in NEUTRAL, and  shift
linkage must be in NEUTRAL position at all
times during winterization procedure.
Tiller Control Outboards
After Winterization
1)
Advance throttle grip to HALF THROTTLE
position. Start the outboard. Outboard runs
at slow idle speed.
1)
After the outboard  shuts itself off,  remove
emergency stop  clip /  key switch.  Do not
start the outboard again after winterization
is completed.
2)
If winterizing  on a  trailer, turn  off water
and detach garden hose. Grease propeller
shaft splines with recommended lubricant,
and re-install propeller.
NOTICE
When  winterizing is  finished,
leave  the   outboard  in   vertical  position
long enough to completely drain the pow-
the
Tiller Control – Typical
erhead.    If    equipped,   disconnect
After outboard runs for  about 15 seconds,    speedometer pickup at the upper connec-
move  throttle grip  to  IDLE  position. Out-    tion  and blow  all  water  out  of the  hose
board continues to run at slow idle speed.     using  air   pressure   of  25   psi  or   less.
Reconnect  speedometer  pickup  after  all
2)
the water has been removed.
3)
Top off oil tank.
Extra engine oil is used during the winteriza-
tion procedure. Some excess oil may appear
on the skeg below the gearcase area. This is
normal.
Avoid potential  oil stains  by placing  a shop
towel or suitable container under  the propel-
ler and skeg for the duration of the storage.
3)
4)
After  outboard  runs  for  another 15  sec-
onds,   advance   throttle   grip    to   HALF
THROTTLE position.  Outboard will accel-
erate to fast idle speed and fog itself.
Allow  outboard to  run  until  it shuts  itself
OFF automatically (less than one minute).
41
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Document TypeBoat Motor Manual. Marine Operator's Engine Guide.
Tags, ,
Model Year2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 72 pages
Document File TypePDF
Publisherevinrude.com
Wikipedia's PageEvinrude Outboard Motors
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website